Carrier Infinity 25VNA8 Manual
Carrier
Varmepumpe
Infinity 25VNA8
Læs nedenfor 📖 manual på dansk for Carrier Infinity 25VNA8 (4 sider) i kategorien Varmepumpe. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/4
Owner’s Manual
A NOTE ABOUT SAFETY
Any time you see this symbol in manuals, instructions and on the
unit, be aware of the potential for personal injury. There are three levels
of precaution:
WARNING signifies hazards that could result in personal injury or
death.
CAUTION is used to identify unsafe practices which would result in
minor personal injury or product and property damage.
NOTE is used to highlight suggestions which will result in enhanced
installation, reliability, or operation.
ABOUT YOUR HEAT PUMP SYSTEM
Our products are designed, tested and built in accordance with US
Department of Energy standardized procedures and other standards;
however, actual operating results and efficiencies may vary based on
manufacturing and supplier tolerances, equipment configuration,
operating conditions and installation practices.
Identifying Your System
Your new Carrier heat pump system is what we call a ”split system.” It
has an outdoor unit and an indoor unit connected to each other with
copper tubing called refrigerant lines. Each of these units has a rating
plate with the model and serial numbers you will need to reference when
calling an authorized Carrier dealer about your system.
Take a few moments now to locate those numbers and record them in the
spaces provided on the cover of this booklet.
USING YOUR NEW CARRIER SYSTEM
Your Carrier heat pump system is controlled by a wall-mounted Infinity
Touch Control or thermostat installed inside your home. See the Infinity
Touch Control or thermostat Homeowner Guide for more details on
system operation.
VARIABLE SPEED OPERATION
You may notice your system runs for longer periods of time. This
system is designed to meet cooling or heating needs of the home at a
wide range of conditions. Your indoor temperature will remain more
consistent with fewer drafts, better humidity control, enhanced comfort
and enhanced energy efficiency.
HEATING AND COOLING YOUR HOME
For heating or cooling operation, make sure the System or Mode control
is set to the appropriate mode. Then, adjust the Temperature control to
your desired setting. Finally, use the Fan control to select Automatic
(turns on and off as heating is needed) or On (runs continuously).
Depending on your typical heating needs, your home comfort system
may also include a supplementary heating source that will automatically
turn on as needed. You may also select this heat source manually if
desired.
OPERATION UNDER EXTREME
CONDITIONS
Your heat pump will run as long as necessary to maintain the indoor
temperature selected on your Infinity Touch Control or thermostat. On
extremely hot days, your heat pump will run for longer periods at a time
than on moderate days. Your system will also run for longer periods of
time under the following conditions:
• Frequent opening of exterior doors
• Operating laundry appliances
• Taking hot showers
• More than the usual number of people present in the home
• More than the normal number of electric lights in use
• Drapes or blinds are open on the sunny side of the home
IMPORTANT HEAT PUMP FACTS
Heat pump systems have a few unique features and operations that you
should be aware of:
• During the heating cycle, your heat pump delivers a constant flow of
air at around 95ºF (35ºC) to about 105ºF (41ºC), compared to sudden
blasts of hot air provided by a typical furnace.
• Ice or frost may form on the outdoor coil during winter heating
operation. Your heat pump will automatically melt the ice using its
defrost cycle. During defrost, you may see steam or fog rising from
the outdoor unit, which is normal. At the beginning and end of the
defrost cycle, you may hear a ”whoosh” sound coming from the unit.
This is normal for heat pump applications.
• Heat pumps installed in areas expecting snow are elevated with
support feet.
SOUND
Your Infinity 18VSheat pump is different from most heating and cooling
systems. Because this is a variable speed system, it is designed to operate
at different speeds depending on the temperature and humidity
conditions. You may notice the sound coming from the outdoor unit
changing from time to time, and from season to season. In winter, the
system will operate at higher speeds as it gets colder outside to maintain
its heating performance. The higher speed produces a higher sound. This
change of speed allows the system to operate more efficiently and
maintain comfortable conditions inside the home. You may also hear a
slight hissing sound when near the outdoor unit in the off-cycle. This is
the sound of system pressure equalization which is required to enable
soft and easy starting of the next cycle. These sounds are normal and do
not represent a problem with your system.
25VNA8 Infinity 18VS®
Variable Speed Heat Pump
with Puron® Refrigerant
WARNING
!
PERSONAL INJURY, DEATH AND / OR PROPERTY
DAMAGE HAZARD
Failure to follow this warning could result in personal injury, death or
property damage.
Improper installation, adjustment, alteration, service, maintenance, or
use can cause explosion, fire, electrical shock, or other conditions
which may cause personal injury or property damage. Consult a
qualified installer, service agency, or your distributor or branch for
information or assistance. The qualified installer or service agency
must use factory-authorized kits or accessories when modifying this
product.
Read and follow all instructions and warnings, including labels shipped
with or attached to unit before operating your new heat pump.
Produkt Specifikationer
| Mærke: | Carrier |
| Kategori: | Varmepumpe |
| Model: | Infinity 25VNA8 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Carrier Infinity 25VNA8 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Varmepumpe Carrier Manualer
28 August 2024
28 August 2024
28 August 2024
28 August 2024
28 August 2024
28 August 2024
28 August 2024
28 August 2024
Varmepumpe Manualer
- Varmepumpe Bosch
- Varmepumpe Siemens
- Varmepumpe Samsung
- Varmepumpe Wilfa
- Varmepumpe Fisher & Paykel
- Varmepumpe Miele
- Varmepumpe LG
- Varmepumpe AEG
- Varmepumpe Electrolux
- Varmepumpe Mitsubishi
- Varmepumpe Hotpoint
- Varmepumpe Atag
- Varmepumpe Qlima
- Varmepumpe Arçelik
- Varmepumpe Baxi
- Varmepumpe Grundig
- Varmepumpe De Dietrich
- Varmepumpe Westinghouse
- Varmepumpe Hisense
- Varmepumpe Blaupunkt
- Varmepumpe Vivax
- Varmepumpe Vaillant
- Varmepumpe Danfoss
- Varmepumpe Tesy
- Varmepumpe Dimplex
- Varmepumpe Junkers
- Varmepumpe Balay
- Varmepumpe Nibe
- Varmepumpe Fujitsu
- Varmepumpe Atlantic
- Varmepumpe Elco
- Varmepumpe Olimpia Splendid
- Varmepumpe Inventum
- Varmepumpe Thermia
- Varmepumpe Midea
- Varmepumpe Viessmann
- Varmepumpe Remeha
- Varmepumpe Stiebel Eltron
- Varmepumpe JANDY
- Varmepumpe Orima
- Varmepumpe Kospel
- Varmepumpe Hydro-Pro
- Varmepumpe AstralPool
- Varmepumpe Waterco
- Varmepumpe Nefit
- Varmepumpe Alpha Innotec
- Varmepumpe Itho-Daalderop
- Varmepumpe AWB
- Varmepumpe Maxicool
- Varmepumpe Wita
- Varmepumpe Fairland
- Varmepumpe Thermor
- Varmepumpe Armstrong
- Varmepumpe Flojet
- Varmepumpe Grundfos
- Varmepumpe Harmopool
- Varmepumpe MRCOOL
- Varmepumpe Wilo
Nyeste Varmepumpe Manualer
8 November 2024
8 November 2024
8 November 2024
8 November 2024
8 November 2024
8 November 2024
8 November 2024
7 November 2024
7 November 2024
7 November 2024