Chapin 19049 Manual

Chapin malingssprøjte 19049

Læs nedenfor 📖 manual på dansk for Chapin 19049 (2 sider) i kategorien malingssprøjte. Denne guide var nyttig for 21 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

Hazard: Improper use or failure to follow instructions can result in explosive failure causing serious

eye or other injury. For safe use of this product you must read and follow all instructions. Do not leave

a pressurized sprayer in the hot sun. Heat can cause pressure build-up. Do not store or leave solution in

tank after use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when

spraying. Never use any tool to remove pump if there is pressure in sprayer. Never stand with face or body

over top of tank when pumping or loosening pump to prevent ejecting pump assembly and/or solution

from striking and injuring you. Never pressurize sprayer by any means other than the original pump.

Do not attempt to modify or repair this product except with original manufacturer’s parts. Never spray

ﬂammable materials or heat, pressure, or gas producing chemicals. Always read and follow manu-

facturer’s instructions before use with this sprayer as some chemicals may be hazardous when used

with this sprayer.

WARNING!

Sk-1113-1

6-5380

Shut-oﬀ handle

Mango de cierre

Poignée du robinet

Printed in U.S.A

6-5373

Holster

Funda

Étui

WARNING: Handling the brass parts of this product will expose you to lead, a chemical known

to the State of California to cause birth defects and other reproductive harm. Wash hands after

handling.

010325-5 (A) R0209

Parts, Piezas, Pièces

Congratulations!

You have just purchased a quality Chapin product.

Questions? Do Not Return To Store.

Call us @ 1-800-950-4458 or www.chapinmfg.com

¡Felicitaciones!

Usted acaba de adquirir un producto de calidad Chapin.

Registre su pulverizador en línea en www.chapinmfg.com/warranty.asp

Félicitations!

Vous avez acheté un produit de qualité Chapin.

Enregistrez dès que possible votre pulvérisateur en ligne à l’adresse suivante:

www.chapinmfg.com/warranty.asp

¿Preguntas? No regrese a la tienda;

llámenos al 1-800-950-4458 o visite www.chapinmfg.com

Questions ? Ne retournez pas au magasin.

Appelez-nous 1-800-950-4458 ou visitez le www.chapinmfg.com

Repair Parts Kit Gaskets and Seals (not included),

Juego de piezas de reparación, empaquetaduras y juntas (no incluido)

Kit de pièces de réparation, joints et garniture d’étanchéité (non inclus) 6-4646

Note: Your particular sprayer may not include all parts pictured above.

Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.

Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.

6-5943

Nozzle 1.0 GPM

Tobera

Buse

6-5797

Nozzle .5GPM

Tobera

Buse

6-6092

Hose Black

Manguera para trabajos pesados Negro

Tuyau pour service intense Noir

1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.

2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are

found, replace hose before using. Replace with original manufacturer’s parts only.

3) Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and Do:

exterior of tank for signs of deterioration of body and bottom. Any sign of deterioration

indicates possible tank weakening and could result in explosive bursting under pressure. If any

of these signs are found, discard tank immediately and replace. Do not attempt to patch leaks,

etc., as this could result in serious injury.

4) Follow Filling, Pressurizing and Spraying Instructions, except use water only. Do:

5) Pump plunger 10-20 strokes and inspect for leaks. Do:

6) Direct shut-oﬀ away from you and open to make sure discharge is not clogged. Do:

7) If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank, Do:

and proceed with Filling, Pressurizing and Spraying Instructions.

3. Pre-Use Check

4. Filling

1) Turn pump handle counterclockwise and remove pumpDo:

2) Prepare spray solution following all directions and safety warnings on chemical label.Do:

3) Fill tank to no more than the proper gallon marker. Do NOT: overﬁll to accommodate Do:

pump.

4) Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank Do:

and tighten securely.

8. Care, Storage and Maintenance

1) Rinse tank thoroughly with water only, empty, reﬁll with water. Follow Filling, Do:

Pressurizing and Spraying Instructions, except pump unit only 8-10 strokes.

2) Open shut-oﬀ and allow water to run through discharge assembly. Do:

3) Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer. Do:

4) Store sprayer tank upside down, with pump removed, in a warm dry location. Do:

5) Periodically oil pump by dropping 10-12 drops of light oil down pump rod through Do:

opening in cover.

1. Hose to Tank

2. Nozzle

Attach the hose by screwing the swivel

nut clockwise and tightening to 37 in.

lbs. Refer to Pre-use check before using.

Attach nozzle to shut-oﬀ handle or extension wand.

TO LOCK HANDLE: Push handle down to depress coil

spring and turn handle 1/4 turn clockwise, then allow handle

to raise into lock position.

5. Pressurizing and Spraying

Lock

Position

TO RELEASE HANDLE: Push down to depress coil spring and

turn handle counterclockwise 1/4 turn, then lift handle.

Pump until you feel resistance.

TO LOCK PUMP: Place pump prongs down into

slots in funnel, turn clamp clockwise to furthest posi-

tion under bottom slot, then turn handle clockwise

until tightly locked and sealed in place.

TO UNLOCK PUMP: Turn handle counterclockwise until

3-prong clamp is loose. en rotate clamp counterclockwise to stop

and lift out.

5. Pressurizing and Spraying, continued

2A 2B

For constant spraying, push down on shut-oﬀ

handle and move locking mechanism away from

you. To release, squeeze handle and move the lock-

ing mechanism back towards you.

6. Fatigue-Free Spraying

7. To Release Pressure

1 : With pump facing away, turn locked handle counterclockwise until air begins to Do

escape. Stop turning handle when you hear air escaping.

2) Stay away from the sprayer until all air has escaped. Do:

6-7703

Extension wand, Vara de extensión, Rallonge

Produkt Specifikationer

Mærke:	Chapin
Kategori:	malingssprøjte
Model:	19049

Har du brug for hjælp?

Hvis du har brug for hjælp til Chapin 19049 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

malingssprøjte Chapin Manualer

17 August 2024

16 August 2024

15 August 2024

15 August 2024

13 August 2024

13 August 2024

12 August 2024

11 August 2024

11 August 2024

9 August 2024

malingssprøjte Manualer

Nyeste malingssprøjte Manualer

2 Oktober 2024

6 September 2024

6 September 2024

6 September 2024

6 September 2024

Wagner SteamForce Speed Pro Manual

5 September 2024

Einhell BT-FSS 500 Manual

2 September 2024

Worx WX020.9 Manual

2 September 2024

Aerotec Mini HVLP Manual

1 September 2024

Wagner W 850 E Manual

1 September 2024