Chief HB026S Manual


Læs nedenfor 📖 manual på dansk for Chief HB026S (1 sider) i kategorien Projektor tilbehør. Denne guide var nyttig for 9 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
HB-026S
V P C M IDEO ROJECTOR EILING OUNT
FOR SIM 2 HT-500 LINK
The Chief HB-026S video projector ceiling mount is designed to provide fast, simple and secure installation of the
SIM 2 HT-500 LINK, Special roll, pitch, yaw and horizontal adjustments simplify projection positioning for image
alignment. The HB-026S mount also has positive registration lock so that the projector may be removed without
losing projector mount registration.
WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL
INJURY! All components must be securely fastened to each other and to the ceiling, AND
the ceiling MUST be capable of supporting 5 times the total weight of the installation. If it
cannot, the ceiling MUST be reinforced.
Unpack and check contents:
(1) Deluxe ceiling mount housing assembly. (6) M6 Washers, flat
(1) SIM 2 mounting bracket (6) M6 x 10mm Screws, PH, Phillips
(4) 5/16” Flange Nuts
INSTALLATION INSTRUCTIONS
1. Turn your projector upside down.
2. Place the SIM 2 mounting bracket on the bottom of the projector so the hooks are facing the back and the six
holes in the bracket line up with the six threaded inserts in the bottom of the projector.
3. Slide the (6) M6 washers on the (6) M6 x 10mm Screws and install them into the six threaded inserts in the
projector. Securely tighten all six mounting screws at this time.
4. Be sure that the method of support you are using for the VCM ceiling mount is securely installed to the
ceiling. If not, the ceiling must be reinforced. Improper installation may result in serious personal injury.
5. Attach the VCM housing to your method of support and tighten firmly so the VCM housing is square to the
screen.
PRECAUTION: Installing a ceiling mount requires the presence of two persons familiar with
mechanical installations. A third assistant is recommended for hanging the projector if it weighs over 75
Lbs.
6. With the help of your assistants, lift the projector and install it to the four studs extending from the mounting
plate. Be sure the SIM 2 mounting plate is seated in slots. Tighten securely using the (4) 5/16” flange nuts.
For projector alignment see attached sheet.Error! No index entries found.
8803-000043 05/05/04
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: chief@chiefmfg.com


Produkt Specifikationer

Mærke: Chief
Kategori: Projektor tilbehør
Model: HB026S

Har du brug for hjælp?

Hvis du har brug for hjælp til Chief HB026S stil et spørgsmål nedenfor, og andre brugere vil svare dig




Projektor tilbehør Chief Manualer

Chief

Chief CHCMS115 Manual

30 August 2024
Chief

Chief CMS036 Manual

21 August 2024
Chief

Chief SSB176 Manual

21 August 2024
Chief

Chief SSM116 Manual

21 August 2024
Chief

Chief CMS006009W Manual

21 August 2024
Chief

Chief SSB440 Manual

21 August 2024
Chief

Chief SSM440 Manual

21 August 2024
Chief

Chief SSB221 Manual

21 August 2024
Chief

Chief SSB078 Manual

21 August 2024
Chief

Chief SSB217 Manual

21 August 2024

Projektor tilbehør Manualer

Nyeste Projektor tilbehør Manualer

Barco

Barco R9861400 Manual

27 September 2024
Barco

Barco R9832766 Manual

15 September 2024
Barco

Barco R9842370 Manual

12 September 2024
Barco

Barco R9855978 Manual

6 September 2024
My Wall

My Wall HL 41 ML Manual

5 September 2024
Speaka

Speaka SP-PWM-200 Manual

5 September 2024
Speaka

Speaka SP-PWM-100 Manual

5 September 2024
Speaka

Speaka PRB-1 Manual

5 September 2024
Roadinger

Roadinger UP-4 QCL Manual

5 September 2024
Panasonic

Panasonic ET-D3LEW300 Manual

5 September 2024