Chief SLM194 Manual
Chief
Projektor tilbehør
SLM194
Læs nedenfor 📖 manual på dansk for Chief SLM194 (1 sider) i kategorien Projektor tilbehør. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
CSAV, Inc., and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. However, CSAV makes no claim that the infor-
mation contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The
information contained in this document is subject to change without notice or obligation of any kind. CSAV makes no representation of warranty, expressed or implied, regarding the
information contained herein. CSAV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
© 2007 Chief Manufacturing, 8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-000263 RevA
8/10/07
SLB-194 and SLM-194 Interface Brackets
for MITSUBISHI SD105U, XD206U, XD206U-G
SLB and SLM series Interface brackets are designed for use with Chief RPA, RPM, and Smart-Lift series projector mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative by calling
1-800-582-6480.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation:
WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE
TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB Interface bracket. If an SLM bracket is being installed proceed to step 2.
1. Screw four thumb screws onto four 10-24 x 5/8" Philips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket onto the bottom of the projector lining up the three holes in the bracket with the three threaded inserts in the
bottom of the projector.
4. Place the M4 X 8mm mounting screws and washers (two washers may be needed on each screw) and start them into the mounting holes
by hand, secure all three fasteners at this time.
NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
(1) Interface Bracket (3) Screw, Pan Head, M4 x 6mm
(4) 10-24 Thumb Nuts ** (6) Washer, Flat, M4
(1) All-Points Security Kit
**Only used when installing SLB Interface brackets.
SLB-194 SLM-194
Towards front of Towards front of
Projector
Projector
Lamp Access Lamp Access
Produkt Specifikationer
| Mærke: | Chief |
| Kategori: | Projektor tilbehør |
| Model: | SLM194 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Chief SLM194 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Projektor tilbehør Chief Manualer
30 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
21 August 2024
Projektor tilbehør Manualer
- Projektor tilbehør Sony
- Projektor tilbehør Panasonic
- Projektor tilbehør Sanyo
- Projektor tilbehør InFocus
- Projektor tilbehør Nedis
- Projektor tilbehør Optoma
- Projektor tilbehør Da-Lite
- Projektor tilbehør Auna
- Projektor tilbehør Casio
- Projektor tilbehør NewStar
- Projektor tilbehør Sanus
- Projektor tilbehør BenQ
- Projektor tilbehør NEC
- Projektor tilbehør Vogel's
- Projektor tilbehør Projecta
- Projektor tilbehør AV:link
- Projektor tilbehør Manhattan
- Projektor tilbehør Christie
- Projektor tilbehør V7
- Projektor tilbehør Vision
- Projektor tilbehør Tempest
- Projektor tilbehør My Wall
- Projektor tilbehør Lindy
- Projektor tilbehør Barco
- Projektor tilbehør Kanto
- Projektor tilbehør Gravity
- Projektor tilbehør Konig & Meyer
- Projektor tilbehør Speaka
- Projektor tilbehør Chipolino
- Projektor tilbehør Unicol
- Projektor tilbehør Peerless
- Projektor tilbehør Gabor
- Projektor tilbehør Premier Mounts
- Projektor tilbehør Elite Screens
- Projektor tilbehør Kingpin Screens
- Projektor tilbehør Smart Media
- Projektor tilbehør Roadinger
Nyeste Projektor tilbehør Manualer
27 September 2024
15 September 2024
12 September 2024
6 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024