Chief SSB064 Manual
Chief
Projector accessoire
SSB064
Læs nedenfor 📖 manual på dansk for Chief SSB064 (1 sider) i kategorien Projector accessoire. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-000055 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-064, SSM-064, SLB-064 and SLM-064 Interface Brackets
SSB-064, SSM-064, SLB-064 and SLM-064 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto the 10-24 x 5/8 Phillips Pan Head Screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the ¼" nylon spacers over the front threaded insert in the bottom of the projector.
4. Place the interface bracket onto the projector (i.e., position the two back holes in the projector align the two holes in the bracket, and the
¼" nylon spacer on the bottom of the projector align with the front ¼" nylon spacer and mounting slotted hole in the front of the bracket).
5. Using the M4 x 12mm screw, position screw through the slotted hole with the nylon spacer, and use the remaining M4 x 8mm screws in
the other threaded inserts. Tighten all fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (2) Screw, Phillips Pan Head, Machine, M4 x 8mm
(4) 10-24 Thumb Nuts ** (1) Screw, Phillips Pan Head, Machine, M4 x 12mm ****
(1) All-Points Security Kit (3) Washer, Flat, M4
(1) 1/2" x .218 x 1/4" Nylon Spacer ****
**Only used when installing SLB/SSB interface brackets. ****Used when mounting surface of projector is recessed.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
SLB-064 SLM-064
(
N
o
t
e
:
S
S
M
-
s
t
y
l
e
i
n
t
e
r
f
a
c
e
b
r
a
c
k
e
t
c
o
n
n
e
c
t
i
o
n
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(
Note: SSB-style interface bracke
t
c
o
n
n
e
c
t
i
o
n
s
a
r
e
e
n
c
i
r
c
l
e
d
)
Towards front of
projector
Towards front of
projector
Produkt Specifikationer
Mærke: | Chief |
Kategori: | Projector accessoire |
Model: | SSB064 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Chief SSB064 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Projector accessoire Chief Manualer
30 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
20 August 2024
Projector accessoire Manualer
- Projector accessoire Sony
- Projector accessoire Panasonic
- Projector accessoire Sanyo
- Projector accessoire InFocus
- Projector accessoire Optoma
- Projector accessoire Da-Lite
- Projector accessoire Auna
- Projector accessoire Casio
- Projector accessoire BenQ
- Projector accessoire NEC
- Projector accessoire Projecta
- Projector accessoire AV:link
- Projector accessoire Manhattan
- Projector accessoire Vision
- Projector accessoire Tempest
- Projector accessoire My Wall
- Projector accessoire Lindy
- Projector accessoire Barco
- Projector accessoire Gravity
- Projector accessoire Konig & Meyer
- Projector accessoire Speaka
- Projector accessoire Chipolino
- Projector accessoire Unicol
- Projector accessoire Premier Mounts
- Projector accessoire Elite Screens
- Projector accessoire Kingpin Screens
- Projector accessoire Smart Media
- Projector accessoire Roadinger
Nyeste Projector accessoire Manualer
15 September 2024
12 September 2024
6 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
4 September 2024