Cocraft HT-28 Manual

Cocraft Loddemaskine HT-28

Læs nedenfor 📖 manual på dansk for Cocraft HT-28 (5 sider) i kategorien Loddemaskine. Denne guide var nyttig for 11 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/5

GREAT BRITAIN • CUSTOMER SERVICE tel. 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk postal 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ

Ver. 20170808

Gas Torch

Art.no 41-1415 Model MRC-982

Please read theentire instruction manual before using theproduct and then save it for future

reference. We reserve theright for any errors in text or images and any necessary changes

made to technical data. In theevent of technical problems or other queries, please contact

our Customer Services.

Safety

Warning

Product description Note:

• Thewidth adjuster (air controller) should not be used when igniting thetorch.

• When used at high altitudes thetorch may experience problems working with theﬂame

length adjuster set to maximum [ + ]. For best results it is recommended that theadjuster

is set half way between [ + ] and [ − ].

Switching off

Theﬂame will extinguish when theignition button is released.

Continuous ame

Caution:

Be very careful when using thegas torch in continuous mode because theﬂame will stay lit

until theswitch (2) is pushed down by hand.

Keep thetorch out of thereach of children.

Never store thetorch at temperatures above 40°C. Never leave thetorch in

direct sunlight or in places which could reach high temperatures.

Thetorch must only be used in well-ventilated areas and well away from

combustible materials and liquids. Caution!

• Do not use thetorch as acigarette lighter.

• Contains extremely ﬂammable gas under pressure.Caution:

• Only reﬁll with butane gas.

• Avoid breathing thefumes from soldering or other heating projects. Ensure that theworking

area is well ventilated.

• Theﬂame of thetorch is very hot and can burn you; make sure to protect your hands and

face. Bear in mind that theﬂame can be difﬁcult to see.

• Hold thetorch upright, theﬂame could go out if thetorch is used in other positions.

• Allow thetorch to cool completely before refuelling it.

• Thetorch must not be modiﬁed or disassembled.

• Do not pierce thegas cylinder and do not throw it into theﬁre even if it is empty.

• Light thetorch with thenozzle pointing away from your face and hands.

• Bear in mind that in certain situations thebutane ﬂame is barely visible.Caution:

• Do not use thetorch if it is damaged.

• Only reﬁll thetorch in awell-ventilated area, free from naked ﬂames, sparks and other persons.

Do not smoke whilst reﬁlling thetorch.

• Read theinstructions on thegas cartridge before reﬁlling thetorch.

• Always have aﬁre extinguisher close by when using thetorch.

• Never try to repair thetorch.

• Only use thetorch in clean environments, away from combustible materials.

• Do not aim theﬂame at any persons or ﬂammable materials.

• Allow thetorch to cool down after use. Make sure that thetorch is switched off and cool

before putting it away for storage.

• Store thetorch vertical.

• Make sure that thesafety lock returns to its original position after use.

• Keep thetorch away from grease and grime. Be careful not to drop thetorch as this may

cause it to malfunction.

• Theﬂame guard can be very hot after use.Caution:

• In case of agas leak (smell of gas), take thetorch outside to awell-ventilated place where

theleak can be checked.

• Never check agas leak using anaked ﬂame, only using aleak detection spray.

• Never leave alighted gas torch unattended.

1. Baseplate (removable)

2. Continuous ﬂame switch

3. Flame guard

4. Flame width adjuster

5. Ignition button

6. Ignition button safety lock

7. Flame length adjuster

8. Filler valve (not in view,

on bottom of torch)

Getting started

Relling gas

• Check that theﬁller valve does not leak before reﬁlling thetorch.

• Only use ahigh quality butane.

1. Shake thegas canister afew times to warm thefuel up.

2. Set theﬂame adjuster (7) to the [ − ] position.

3. Turn thetorch and thegas canister upside down and insert

thenozzle of thegas canister into theﬁller valve (8).

4. Stand thetorch on its base and leave it for at least 2 minutes

for thegas to stabilise before use.

Operating instructions

Igniting the torch

1. Set theﬂame adjuster to the [ + ] position.

2. Slide thesafety lock (6) down until it

clicks into thebottom setting.

3. Press theignition button (5) to light

thegas.

• Note: For safety reasons, theignition button cannot be pressed unless thesafety lock is off.

• Never leave thetorch unattended after thesafety lock has been taken off. Caution:

To put thesafety lock back on, theignition button must be depressed, thesafety lock

will then return to its original position.

Setting the ame

1. Hold theignition button down after ignition.

2. Adjust thelength of theﬂame by sliding theadjuster towards:

-[ + ] to increase thelength of theﬂame.

-[ − ] to decrease thelength of theﬂame.

For best results theﬂame should be 10−25mm in length.

If theﬂame is too long it will be unstable and thetorch will use more gas than necessary.

3. Thewidth of theﬂame can be adjusted by sliding theair controller (4) forwards.

If theadjuster is released it will spring back to its original position.

1. Depress theignition button and

slide thecontinuous ﬂame switch (2)

upwards.

2. Release theignition button and

theﬂame will continue to burn.

3. Slide thecontinuous ﬂame switch down and

theﬂame will go out.

Care and maintenance

Clean theexterior of theproduct using alightly moistened cloth. Use only mild cleaning agents,

never solvents or corrosive chemicals.

Responsible disposal

This symbol indicates that this product should not be disposed of with general

household waste. This applies throughout theentire EU. In order to prevent

any harm to theenvironment or health hazards caused by incorrect waste

disposal, theproduct must be handed in for recycling so that thematerial can

be disposed of in aresponsible manner. When recycling your product, take it to

your local collection facility or contact theplace of purchase. They will ensure

that theproduct is disposed of in anenvironmentally sound manner.

Specications

Gas canister volume 28ml

Fuel Butane gas (sold separately)

Fuel consumption 50.9g/h (0.7kW)

Rated burn time 90–120min

Height 7.5cm

Weight 260g

Produkt Specifikationer

Mærke:	Cocraft
Kategori:	Loddemaskine
Model:	HT-28

Har du brug for hjælp?

Hvis du har brug for hjælp til Cocraft HT-28 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Loddemaskine Cocraft Manualer

Cocraft KK-015P Manual

16 August 2024

Cocraft HS 30L Manual

12 August 2024

Cocraft HT-28 Manual

7 August 2024

Loddemaskine Manualer

Nyeste Loddemaskine Manualer

Weller ZeroSmog Guard 2 Manual

12 Januar 2025

Stamos S-LS-15 Basic Manual

4 Januar 2025

Stamos S-LS-18 Basic Manual

4 Januar 2025

Weller Pyropen Cordless Manual

3 Januar 2025

Weller WPA2N Manual

3 Januar 2025

Velleman VTSSC30N Manual

1 Januar 2025

Velleman VTSS7 Manual

1 Januar 2025

Velleman VTSS230 Manual

1 Januar 2025

Velleman VTSS220 Manual

1 Januar 2025

Weller ZeroSmog Guard Manual

31 December 2025