Cotech 36-6706 Manual

Cotech Lettelse 36-6706

Læs nedenfor 📖 manual på dansk for Cotech 36-6706 (5 sider) i kategorien Lettelse. Denne guide var nyttig for 3 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/5
GREAT BRITAIN CUSTOMER SERVICE
tel 020 8247 9300 customerservice@clasohlson.co.uk www.clasohlson.co.uk 10 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZe-mail internet postal
Ver. 20170809
LED Under Cabinet Light
Art.no 36-6706, 36-6707
Please read theentire instruction manual before using theproduct
and then save it for future reference. We reserve theright for
any errors in text or images and any necessary changes made
to technicaldata. In theevent of technical problems or other
queries, please contact our Customer Services.
Safety
3. Press down on theconnector and disconnect thewires.
Placethelamp module to oneside.
6. Reassemble thelight fitting by first reconnecting thelamp
module to thehousing at theconnection which was
disconnected at step 3 above and then fitting thelamp
module back onto thehousing.
Care and maintenance
Use adry cloth to wipe thelightttingclean.
Thelamps are non-replaceable. Nevertry to open
thelamp modules or modify thelight fitting in anyway.
Responsible disposal
The light source contained in this luminaire shall
only be replaced by the manufacturer or his service
agent or a similar qualified person. Caution to
the risk of electric shock during installation or
maintenance.
This product must only be installed by aqualified electrician.
This product is only intended for indoor hard-wired
installation.
The operating temperature of the luminaire is −30 to 40 °C.
Installation
1. Warning: Before beginning any electrical
installation always disconnect thepower
to thecircuit you are working on, either by
turning off themain circuit breaker or by
removing thefuse from theconsumerunit.
2. Carefully pry thelamp module away from themain
housing of thelighttting. Makesure that thewires Note:
connecting thelamp module and thehousing are not
damaged.
4. Pass thepower supply
cable through one of
thegrommets in thewall
of the housing. Becareful
not to damage thecable
entry grommet. Connect
thepower supply cable to
theterminalblock.
5. Screw thehousing onto themounting surface. Itcan be
mounted flat on asingle surface or angled between two
surfaces at right angles to eachother. Usetheincluded
screws and plugs or another appropriate fastening method.
36-6706
36-6707
This symbol indicates that this product should not
be disposed of with general householdwaste.
Thisapplies throughout theentire EU. Inorder to
prevent any harm to theenvironment or health
hazards caused by incorrect waste disposal,
theproduct must be handed in for recycling so
that thematerial can be disposed of in arespon-
sible manner. Whenrecycling your product, take it
to your local collection facility or contact theplace
of purchase. Theywill ensure that theproduct is
disposed of in anenvironmentally sound manner.
Specifications
36-6706
Rated voltage 220–240V
AC, 50/60Hz
Power 3.5W
Length 457mm
IP rating
36-6707
Rated voltage 220–240V
AC, 50/60Hz
Power 9.5W
Length 718mm
IP rating
Only intended for indooruse.


Produkt Specifikationer

Mærke: Cotech
Kategori: Lettelse
Model: 36-6706

Har du brug for hjælp?

Hvis du har brug for hjælp til Cotech 36-6706 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Lettelse Cotech Manualer

Cotech

Cotech IPC15A3A-D3 Manual

30 August 2024
Cotech

Cotech EMP701MD Manual

27 August 2024
Cotech

Cotech IPC30SA1A Manual

16 August 2024
Cotech

Cotech JF4011G Manual

14 August 2024
Cotech

Cotech RP120W Manual

10 August 2024
Cotech

Cotech 36-4137 Manual

8 August 2024
Cotech

Cotech WCVC012W10 Manual

5 August 2024
Cotech

Cotech TOE-12 Manual

5 August 2024
Cotech

Cotech 36-6078 Manual

5 August 2024

Lettelse Manualer

Nyeste Lettelse Manualer