Gigabyte GA-7VT880 Pro Manual

Gigabyte Bundkort GA-7VT880 Pro

Læs nedenfor 📖 manual på dansk for Gigabyte GA-7VT880 Pro (47 sider) i kategorien Bundkort. Denne guide var nyttig for 22 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/47
When you installing AGP card, please make sure the following notice
is fully understood and practiced. If your AGP card has "AGP 4X/8X
(1.5V) notch"(show below), please make sure your AGP card is AGP
4X/8X.
Caution: AGP 2X card is not supported by VIA KT880. You might
experience system unable to boot up normally. Please insert an AGP
4X/8X card.
Example 1: Diamond Vipper V770 golden finger is compatible with 2X/4X
mode AGP slot. It can be switched between AGP 2X(3.3V) or 4X(1.5V) mode
by adjusting the jumper. The factory default for this card is 2X(3.3V). The
GA-7VT880 Pro / GA-7VT880-L / GA-7VT880 (or any AGP 4X/8X only)
motherboards might not function properly, if you install this card without
switching the jumper to 4X(1.5V) mode in it.
Example 2: Some ATi Rage 128 Pro graphics cards made by "Power Color",
the graphics card manufacturer & some SiS 305 cards, their golden finger is
compatible with 2X(3.3V) / 4X(1.5V) mode AGP slot, but they support
2X(3.3V) only. The GA-7VT880 Pro / GA-7VT880-L / GA-7VT880 (or any
AGP 4X/8X only) motherboards might not function properly, If you install this
card in it.
Note : Although Gigabyte's AG32S(G) graphics card is based on ATi Rage
128 Pro chip, the design of AG32S(G) is compliance with AGP 4X(1.5V)
specification. Therefore, AG32S(G) will work fine with VIA KT880 based
motherboards.
Before you install PCI cards, please remove the Dual BIOS label from PCI
slots if there is one.
AGP 4X/8X notch


Produkt Specifikationer

Mærke: Gigabyte
Kategori: Bundkort
Model: GA-7VT880 Pro

Har du brug for hjælp?

Hvis du har brug for hjælp til Gigabyte GA-7VT880 Pro stil et spørgsmål nedenfor, og andre brugere vil svare dig