Gigabyte GA-8KNXP Ultra Manual

Gigabyte Moederbord GA-8KNXP Ultra

Læs nedenfor 📖 manual på dansk for Gigabyte GA-8KNXP Ultra (112 sider) i kategorien Moederbord. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/112
When you installing AGP card, please make sure the following notice
is fully understood and practiced. If your AGP card has "AGP 4X/8X
(1.5V) notch"(show below), please make sure your AGP card is AGP
4X/8X.
Caution: AGP 2X card is not supported by Intel® 845(GE/PE) / 845(E/G) /
850(E) / E7205 / 865(G/PE/P) / 875P. You might experience system
unable to boot up normally. Please insert an AGP Pro 4X/8X card.
Example 1: Diamond Vipper V770 golden finger is compatible with 2X/4X
mode AGP slot. It can be switched between AGP 2X(3.3V) or 4X(1.5V) mode
by adjusting the jumper. The factory default for this card is 2X(3.3V).
The GA-8KNXP Ultra (or any AGP Pro 4X/8X only) motherboards might not
function properly, if you install this card without switching the jumper to 4X
(1.5V) mode in it.
Example 2: Some ATi Rage 128 Pro graphics cards made by "Power Color",
the graphics card manufacturer & some SiS 305 cards, their golden finger is
compatible with 2X(3.3V) / 4X(1.5V) mode AGP slot, but they support
2X(3.3V) only. The GA-8KNXP Ultra (or any AGP Pro 4X/8X only)
motherboards might not function properly, If you install this card in it.
Note : Although Gigabyte's AG32S(G) graphics card is based on ATi Rage
128 Pro chip, the design of AG32S(G) is compliance with AGP 4X(1.5V)
specification. Therefore, AG32S(G) will work fine with Intel ®
845(GE/PE) /
845(E/G) / 850(E) / E7205 / 865(G/PE/P) / 875P based motherboards.
Before you install PCI cards, please remove the Dual BIOSlabel from PCI
slots if there is one.
AGP 4X/8X notch


Produkt Specifikationer

Mærke: Gigabyte
Kategori: Moederbord
Model: GA-8KNXP Ultra

Har du brug for hjælp?

Hvis du har brug for hjælp til Gigabyte GA-8KNXP Ultra stil et spørgsmål nedenfor, og andre brugere vil svare dig