Gigabyte GA-8SG667 Manual

Gigabyte Bundkort GA-8SG667

Læs nedenfor 📖 manual på dansk for Gigabyte GA-8SG667 (86 sider) i kategorien Bundkort. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/86
When you installing P AG card, please make sure the following
notice is fully understood and practiced. If your AGP card has
"AGP 4X/8X(1.5V) notch"(show below), please make sure your AGP
card is AGP 4X/8X(1.5V).
Caution: AGP 2X card is not supported by SiS
® 648. You might
experience system unable to boot up normally. Please insert an
AGP 4X/8X card.
Example 1: Diamond Vipper V770 golden finger is compatible with 2X/4X
mode AGP slot. It can be switched between AGP 2X(3.3V) or 4X(1.5V)
mode by adjusting the jumper. The factory default for this card is
2X(3.3V). The GA-8SG667 (or any AGP 4X only) motherboards might
not function properly, if you install this card without switching the jumper
to 4X(1.5) mode in it.
Example 2: Some ATi Rage 128 Pro graphics cards made by “Power
Color”, the graphics card manufacturer & some SiS 305 cards, their
golden finger is compatible with 2X(3.3V)/4X(1.5V) mode AGP slot, but
they support 2X(3.3V) only. The GA-8SG667 (or any AGP 4X only)
motherboards might not function properly, If you install this card in it.
Note : Although Gigabyte's AG32S(G) graphics card is based on
ATi Rage 128 Pro chip, the design of AG32S(G) is compliance
with AGP 4X(1.5V) specification. Therefore, AG32S (G)will work
fine with SiS® 648 based motherboards.
AGP 4X/8X notch


Produkt Specifikationer

Mærke: Gigabyte
Kategori: Bundkort
Model: GA-8SG667

Har du brug for hjælp?

Hvis du har brug for hjælp til Gigabyte GA-8SG667 stil et spørgsmål nedenfor, og andre brugere vil svare dig