Homedics PX-100 Manual


Læs nedenfor 📖 manual på dansk for Homedics PX-100 (2 sider) i kategorien Måleudstyr. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
IMPORTANT PRODUCT NOTICES AND
SAFETY INSTRUCTIONS
This is a home healthcare product only and is solely intended
for sports and recreational use. It is not intended to serve as a
substitute for the advice of a physician or medical professional.
The readings from this pulse oximeter are for reference only.
Consult a healthcare professional for interpretation of your
pulse oximeter measurements. Contact a physician if you
have or suspect any medical problem. Do not change your
medications without the advice of your physician or healthcare
professional.
The pulse display is not suitable for checking the frequency of
pacemakers.
Use the pulse oximeter only for its intended use.
Please keep this device away from children. Small parts such
as battery and battery door could be hazardous if swallowed.
The lanyard could cause strangulation in conditions when
twisted around the neck.
This pulse oximeter should not be used where alarms are
required when taking measurements.
For greatest accuracy, wait 10 minutes after exercising,
bathing, eating, drinking beverages with alcohol or caffeine, or
smoking to measure blood oxygen level.
Use only 3.6V “½ AA” Lithium battery for power supply.
If there is any damage to the product, including blurring of the
LCD display, please contact HoMedics Consumer Relations at
1-800-466-3342.
Do not use cellular phones or other radio frequency producing
devices near the working device as it may interfere with proper
operation of the pulse oximeter.
Not for use by or on persons under the age of 18 years old.
CARE, MAINTENANCE & CLEANING
Use a cotton swab with isopropyl alcohol solution (70%) to clean
the inside of the finger sleeve or the outside of the unit.
DO NOT use any other liquid or sprays on the oximeter for
cleaning purposes.
Under normal usage conditions, this device does not require
calibration or technical maintenance other than infrequent
replacement of the battery.
Leaky batteries can damage the unit. Remove the battery
when the unit will not be used for a long time.
This product should only be used on the fingers.
DO NOT disassemble this device. If in need of repair, refer to
the warranty section of this manual.
DO NOT use the product if the finger sleeve changes color or
is no longer able to secure on finger.
DO NOT subject this device to extreme shocks (do not drop
on floor).
DO NOT drop or insert any object into any opening.
DO NOT immerse the unit in water as this will result in damage
to the unit.
DO NOT subject this device to extreme temperatures,
humidity, moisture, or direct sunlight. Protect from dust.
If the unit is stored near freezing, allow it to acclimate to room
temperature before use.
This monitor may not meet its performance specifications if
stored or used outside of these temperature and humidity
ranges:
TROUBLESHOOTING
If any abnormality arises during use, please check the following points:
ABOUT PULSE OXIMETERS
This pulse oximeter uses Optimetrix™ technology, which utilizes
revolutionary optical sensor technology to measure both blood
oxygen saturation ( SpO2%) levels and pulse rate. By placing the
finger into the sleeve and one-touch of a button, this device will
send both red and infrared lights into the skin to collect data and
display your blood oxygen and pulse rate.
NAME/FUNCTION OF EACH PART
Finger Sleeve
Multi-directional
Button
LCD Display
Battery
Compartment
Other Accessories Included:
• 1 “½ AALithium Battery
(included in the unit)
• Storage Pouch
• Lanyard
Storage Environment
Temperature
-4°F ~ 158°F
(-20°C ~ 70°C)
Humidity: Less than 95%
non-condensing
Operation Environment
Temperature
39°F ~ 107°F
(4°C ~ 42°C)
Humidity: Less than 95%
non-condensing
DISPLAY EXPLANATIONS
Signal
Strength
Indicator
Pulse Rate
Blood Oxygen
Level
Sensor Off Indicator: Appears when the finger
has been removed from the finger sleeve.
Weak Battery Symbol: Flashes when battery
should be replaced.
Pulse Rate: Shows the pulse rate per minute.
SYMPTOMS POSSIBLE
CAUSES CORRECTION
Pulse Rate or
SpO2 is not
appearing.
Position of the
finger is not
correct.
Reposition the finger into the
correct position and measure
again.
The pulse
oximeter will
not power on.
Battery has
run down.
Replace the battery with a
single 3.6V “½ AA” Lithium
battery.
Screen
orientation is
upside down.
Viewing angle
needs to be
adjusted.
Press the Multi-directional
button for up to 2 seconds
and the screen will rotate 180°.
LIMITED TWO YEAR WARRANTY
HoMedics sells its products with the intent that they are
free of defects in manufacture and workmanship for a
period of two years from the date of original purchase,
except as noted below. HoMedics warrants that its prod-
ucts will be free of defects in material and workmanship
under normal use and service. This warranty extends
only to consumers and does not extend to Retailers.
To obtain warranty service on your HoMedics product,
contact a Consumer Relations Representative by tele-
phone at 1-800-466-3342 for assistance. Please make
sure to have the model number of the product available.
HoMedics does not authorize anyone, including, but
not limited to, Retailers, the subsequent consumer
purchaser of the product from a Retailer or remote
purchasers, to obligate HoMedics in any way beyond
the terms set forth herein. This warranty does not cover
damage caused by misuse or abuse; accident; the
attachment of any unauthorized accessory; alteration to
the product; improper installation; unauthorized repairs
or modifications; improper use of electrical/power
supply; loss of power; dropped product; malfunction
or damage of an operating part from failure to provide
manufacturer’s recommended maintenance; transporta-
tion damage; theft; neglect; vandalism; or environmental
conditions; loss of use during the period the product is
at a repair facility or otherwise awaiting parts or repair;
or any other conditions whatsoever that are beyond the
control of HoMedics. This warranty is effective only if
the product is purchased and operated in the country in
which the product is purchased. A product that requires
modifications or adoption to enable it to operate in
any other country than the country for which it was
designed, manufactured, approved and/or authorized,
or repair of products damaged by these modifications is
not covered under this warranty.
THE WARRANTY PROVIDED HEREIN SHALL BE THE
SOLE AND EXCLUSIVE WARRANTY. THERE SHALL
BE NO OTHER WARRANTIES EXPRESS OR IMPLIED
INCLUDING ANY IMPLIED WARRANTY OF MERCHANT-
ABILITY OR FITNESS OR ANY OTHER OBLIGATION
ON THE PART OF THE COMPANY WITH RESPECT TO
PRODUCTS COVERED BY THIS WARRANTY. HOMEDICS
SHALL HAVE NO LIABILITY FOR ANY INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES. IN NO
EVENT SHALL THIS WARRANTY REQUIRE MORE THAN
THE REPAIR OR REPLACEMENT OF ANY PART OR
PARTS WHICH ARE FOUND TO BE DEFECTIVE WITHIN
THE EFFECTIVE PERIOD OF THE WARRANTY. NO
REFUNDS WILL BE GIVEN. IF REPLACEMENT PARTS
FOR DEFECTIVE MATERIALS ARE NOT AVAILABLE,
HOMEDICS RESERVES THE RIGHT TO MAKE PRODUCT
SUBSTITUTIONS IN LIEU OF REPAIR OR REPLACE-
MENT.
This warranty does not extend to the purchase of
opened, used, repaired, repackaged and/or resealed
products, including but not limited to sale of such
products on Internet auction sites and/or sales of
such products by surplus or bulk resellers. Any and all
warranties or guarantees shall immediately cease and
terminate as to any products or parts thereof which are
repaired, replaced, altered, or modified, without the prior
express and written consent of HoMedics.
This warranty provides you with specific legal rights.
You may have additional rights which may vary from
state to state. Because of individual state regulations,
some of the above limitations and exclusions may not
apply to you.
For more information regarding our product line in the
USA, please visit: www.homedics.com.
HoMedics and Optimetrix are registered trademarks of HoMedics, LLC.
©2012 HoMedics, LLC. All Rights Reserved.
IB-PX100
PX-100 Pulse Oximeter: Part# 90350000
Cat# 10957800
REPLACING BATTERY
1. The battery compartment is located
on the top of the unit. Remove battery
cover by pressing down and sliding
the battery cover off. (fig. 1)
2. Install or replace the battery according
to the polarity indicator located inside
the compartment. Use only 3.6V
½ AA” sized Lithium batteries. (fig. 2)
3. Replace the battery cover by inserting
it back into place. (fig. 3)
Replace the batteries if:
The weak battery symbol appears on
the display.
Nothing appears on the display after
the finger is inserted into the sleeve
and the button is pressed.
Note: Batteries are hazardous waste. Do
not dispose of them together with the
household garbage.
Fig. 2
Fig. 3
Fig. 1
MEASUREMENT
PROCEDURE
If you are using this pulse oximeter for the
first time, please remove the pull tab from
the battery door.
1. Hold the pulse oximeter so that the
picture of the finger nail on the finger
sleeve is facing up.
2.
Gently place any finger into the finger
sleeve as shown in the diagram
(fig. A). Slightly press on the sides of the
finger sleeve to ease the finger inside.
3. Turn the hand over so that the LCD
screen is now facing you and your
finger is pointed up (fig. B).
4. Push the Multi-directional button
to initiate readings (fig. C).
5. Continue to vertically hold the pulse
oximeter to enable readings
6. To change the direction of the LCD
screen display by 180°, press the Multi-
directional button for up to two (2)
seconds.
Note:
Signal strength should be greater than
one bar to indicate a proper reading
(fig. D).
In the event of weak signal strength,
please switch fingers and/or hand and
try again.
For greatest accuracy, limit hand motion
during measurement.
When the finger is removed, the pulse
oximeter will turn off after 10 seconds.
Fig. A
Fig.B
Fig.C
Fig.D
For service or repair,
do not return this unit
to the retailer. Contact
HoMedics Consumer
Relations at:
Email:
cservice@
homedics.com
Phone:
1-800-466-3342
Business Hours:
8:30am-7pm ET
Monday-Friday
Distributed by
®
HoMedics, LLC
3000 Pontiac Trail
Commerce
Township, MI
48390
Printed in China
PRODUCT SPECIFICATIONS
Effective Measuring Range
Saturation 70 to 99%
Pulse Rate 40 to 250 bpm
Resolution 1 digit
Accuracy
Saturation (70%-99%) ±2% or ±2 digits
Pulse Rate ±3% or ±3 digits
Display
Saturation 2 characters
Pulse Rate 3 characters
Signal Indications: Flashing Heart Icon, Sensor ‘Off’
and Signal intensity strength,
battery indication - near empty
Power Requirements 3.6V “½ AA size Lithium battery
Battery life up to 300 Hours
Type BF Applied Part Spot Measurement No alarms
P
l
e
a
s
e
T
a
k
e
A
M
o
m
e
n
t
N
o
w
Register
Your Product At:
www.homedics.com/register
Your valuable input regarding this
product will help us create
the products you will
want in the future.
Deluxe Pulse Oximeter
Note: When changing the orientation of the screen, the pulse
rate will be shown on the top near the blinking Pulse Rate Icon,
and the blood oxygen level will be shown on the bottom of the
LCD display.
SpO2


Produkt Specifikationer

Mærke: Homedics
Kategori: Måleudstyr
Model: PX-100

Har du brug for hjælp?

Hvis du har brug for hjælp til Homedics PX-100 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Måleudstyr Homedics Manualer

Homedics

Homedics PX-100 Manual

20 August 2024

Måleudstyr Manualer

Nyeste Måleudstyr Manualer

Uni-T

Uni-T UT18D Manual

16 December 2024
Uni-T

Uni-T UT363s Manual

16 December 2024
Uni-T

Uni-T UT383s Manual

16 December 2024
Steinberg

Steinberg SBS-MT-100 Manual

16 December 2024
Steinberg

Steinberg SBS-SM-135C Manual

16 December 2024
Steinberg

Steinberg SBS-LF-147 Manual

16 December 2024
Steinberg

Steinberg SBS-DL-123E Manual

15 December 2024
Steinberg

Steinberg SBS-LF-116 Manual

15 December 2024
Steinberg

Steinberg SBS-LF-140 Manual

15 December 2024