Hotpoint CS1A 250 H Manual

Hotpoint Fryser CS1A 250 H

Læs nedenfor 📖 manual på dansk for Hotpoint CS1A 250 H (5 sider) i kategorien Fryser. Denne guide var nyttig for 13 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/5
INSTRUCTIONS FOR USE
EN
DIAGRAM OF THE APPLIANCE (Fig. 1)
A. Handle.
B. Safety lock (if provided).
C. Gasket.
D. Separator (if provided).
E. Defrost water drain plug.
F. Control panel.
G. Side motor cooling grille.
DIAGRAM OF THE CONTROL PANEL (Fig. 2)
1. Temperature adjustment thermostat.
2. Red light (if provided): indicates that the temperature
inside the product is not low enough.
3. Green LED (if provided): when lit, indicates that the
appliance is running.
4. : Yellow/orange illuminated button (if provided)
activates/deactivates the fast freeze function.
When lit, it indicates that the fast freeze function is active.
The fast freeze function automatically deactivates after
about 50 hours.
The exact conguration of the control panel may vary
according to the model.
BEFORE USING THE APPLIANCE
Your new appliance is designed to be used in the
household and similar applications such as:
- kitchen areas in shops, oces and other working
environments
- farm houses
- by clients in hotels, motels, residences, bed &
breakfasts.
The product must only be used to store frozen food, to
freeze fresh food and to make ice.
Regulations require the appliance to be earthed. The
manufacturer declines all liability for injury to persons
or animals and for damage to property resulting
from failure to observe the above procedures and
reminders.
1. After unpacking, make sure that the appliance is
undamaged and that the door closes perfectly, with the
gasket remaining intact. Any damage must be reported to
your retailer within 24 hours after delivery of the appliance.
2. Wait at least two hours before switching the appliance on
in order to ensure the refrigerant circuit is fully ecient.
3. Installation and electrical connection must be carried out
by a qualied technician, according to the manufacturer’s
instructions and local safety regulations.
4. Clean the inside of the appliance before using it.
Before connecting the appliance to the mains supply,
ensure that the voltage corresponds to that given on the
rating plate located on the rear of the appliance.
Electrical connections must be made in accordance
with local regulations.
INSTALLATION
Unpack the appliance.
Remove the 4 spacers inserted between the door
and the appliance. (Fig 3)
Make sure the defrost water drain plug (if provided) is
correctly positioned (E).
For optimum appliance operation and to avoid damage
when the door is opened, leave a space of at least 7 cm
from the rear wall and 7 cm at the sides. (Fig. 4)
Fit the accessories (if provided).
SWITCHING ON THE APPLIANCE
The appliance is factory set for optimum operation at a
temperature of -18°C.
Plug in the appliance.
The green LED lights up (if provided).
Also the red LED (if provided) will switch on because
the temperature inside the appliance is not yet
suciently low for food storage. The red LED will
normally switch o within the rst six hours after the
appliance is switched on.
After connecting the appliance to the mains supply and
when the optimal temperature has been reached (this
phase takes about 1 hour during which the lid will not
open), ensure that the fast freeze button is not pressed
(the yellow LED, if provided, is o).
Place food inside the product only when the red LED
(if provided) has switched o.
Thanks to the ecient lid seal, the appliance lid will not
re-open easily immediately after closing. Wait a few
minutes before re-opening the lid of the appliance.
TEMPERATURE ADJUSTMENT
Use the thermostat to select the ideal storage temperature.
To adjust the internal temperature, proceed as follows:
Turn the thermostat knob to 1 for a storage temperature
that is less cold.
Turn the thermostat knob to 6 for a colder storage
temperature.
For partial loads, or when the load indicator is below the
“e” symbol inside the appliance, it is advisable to move
the thermostat to the lower position (on “e”, if present on
the thermostat scale)
FREEZING FOOD
Preparation of fresh food for freezing
Before freezing, wrap and seal fresh food in: aluminium
foil, cling lm, air and water-tight plastic bags,
polyethylene containers with lids, provided they are
suitable for freezing foods.
Food must be fresh, mature and of prime quality in order
to obtain high quality frozen food.
Fresh vegetables and fruit should preferably be frozen
as soon as they are picked to maintain the full original
nutritional value, consistency, colour and avour.
Always leave hot food to cool before placing in the
appliance.
Freezing fresh food
Place foods to be frozen in direct contact with the walls
of appliance (Fig. 5):
A) - foods to be frozen,
B) - foods already frozen.
Avoid placing foods to be frozen in direct contact with
food already frozen.


Produkt Specifikationer

Mærke: Hotpoint
Kategori: Fryser
Model: CS1A 250 H

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint CS1A 250 H stil et spørgsmål nedenfor, og andre brugere vil svare dig




Fryser Hotpoint Manualer

Fryser Manualer

Nyeste Fryser Manualer

Zanussi

Zanussi ZFC26400WA Manual

22 December 2024
Bosch

Bosch KSZ2AVT00 Manual

22 December 2024
Bosch

Bosch KSZ2AVO00 Manual

22 December 2024
Bosch

Bosch KIL42NSE0G Manual

22 December 2024
Bosch

Bosch KGN497WDFG Manual

22 December 2024
Electrolux

Electrolux RNT6TE19S Manual

21 December 2024
Electrolux

Electrolux RNT6TE19S0 Manual

21 December 2024
Electrolux

Electrolux KTS5LE12S Manual

21 December 2024
Electrolux

Electrolux EUH8000W Manual

21 December 2024
Electrolux

Electrolux ENT5ME32W Manual

21 December 2024