Kuzco Victoria MP3009 Manual

Kuzco Lys Victoria MP3009

Læs nedenfor 📖 manual på dansk for Kuzco Victoria MP3009 (1 sider) i kategorien Lys. Denne guide var nyttig for 4 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
INSTALLATION SHEET
MP3009
1.
2.
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20150821
START FROM HERE
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed
electrician
Prepare everything in clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
All Kuzco LED fixtures come with pre-wired LED
module(s).
• Unless instructed to do so, please do not touch any part
of the LED module(s) as any unnecessary contact with the
module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) dimmer is
required.
2a.
Ceiling LED pendants.
3. 3b.
4a.
3a.
You have now completed the installation of your fixture,
enjoy.
4.
Remove the fixture from its original packaging. Remove the
canopy mounting bar from within the canopy by removing the
decorative nuts. Mount the hanging bar (with canopy screws
facing downward) to the junction box make sure all screws screw
into wood not just drywall.
Before you mount the canopy to the mounting bar please
select the desired lengths you wish the pendants to hang.
To shorten the cable just push the cable up into the canopy
nipple ( . To lengthen the wire push up the tiny nipple (2a) 2a)
where the wire comes through pull the wire to your desired
length then release the nipple and the wire will stay in place.
Once you have adjusted all the wires to the desired lengths,
move all the wire grips down each the wire from inside the
canopy until the grip hold the wire closest to where the wire
enters into the canopy.
You are now ready to mount the canopy to the mounting cross
bar first connect all wires correctly L live wire (white to white)
N neutral wire (black to black) and G ground (green to green)
with provided marrets from the hardware package . Align 3a)
the four screw hanging downward from the crossbar to the four
holes inside the canopy. Push the canopy up towards the
ceiling so the screws point through the holes in the canopy.
You can then screw on the four decorative nuts onto the (3b)
four screws pointing through the canopy to securely install the
canopy to the mounting bar.
LED Engines are built in. Push the glass ( up to the LED4a)
engines (4b) and thread turning clockwise.
5.
4b.
L
N


Produkt Specifikationer

Mærke: Kuzco
Kategori: Lys
Model: Victoria MP3009

Har du brug for hjælp?

Hvis du har brug for hjælp til Kuzco Victoria MP3009 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Lys Kuzco Manualer

Lys Manualer

Nyeste Lys Manualer