Legrand 364765-02 Manual

Legrand Speaker 364765-02

Læs nedenfor 📖 manual på dansk for Legrand 364765-02 (3 sider) i kategorien Speaker. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/3
INSTRUCTION / INSTALLATION SHEET
evōQ™ 1000 In-Ceiling and In-Wall
Speakers
IS-0294 Rev. B
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2006 by On-Q/Legrand All Rights Reserved. Page 1 of 3
1. Introduction
On-Q/Legrand offers evōQ™ 1000 6.5” In-Ceiling (P/N MS1650)
and In-Wall (P/N MS1651) speakers which are optimized for
audio distribution (central sound). They are 2-way speakers that
feature Poly woofers and Mylar tweeters (see Figure 1). These
speakers come with dual templates with center markings and
paint rings.
Disclaimer: Make sure you are in compliance with local
building codes before installing these speakers. On-
Q/Legrand evōQ™ 1000 Speakers are suitable for moisture
rich environments such as bathrooms, saunas and outdoor
applications (not directly exposed to the weather).
2. Description
The On-Q/Legrand evōQ™ 1000 speakers are made of a tough semi-flexible plastic frames and feature a
perforated metal grill. All evóQ speakers, except sub woofers, are paint-able. They also come with painting
shields to protect the drivers while painting. These speakers are suitable for moisture rich environments.
They also feature flip out tabs for easy installation and removal.
3. Installation
Installation of the evōQ™ 1000 speakers is best accomplished at multiple times during new construction, at
“Rough-in” before the drywall is installed, and at “Trim-out” after the drywall is installed and painted.
A. “Rough-in” steps:
NOTE: It is recommended that a minimum of 16 gauge, 2 conductor wire be
used for most applications from the amplifier or volume control to the
speaker. Different gauges can, and should, be used based upon the
distance of the intended run or quality of installation (see Figure 2).
NOTE: All On-Q/Legrand lyriQ™ Audio components accommodate wire
gauges from 18 to 14.
1. Run x/2 conductor (x=gauge preference) stranded speaker wire from the
distribution/volume control to the speaker location (pre-wiring).
2. When pre-wiring, leave 4 to 6 feet of wire at the speaker’s intended
location. Use a strip of cardboard stapled to the joints/studs with a
hole through it as a wire place holder for the drywall installers (see
Figure 3).
3. Strip off 3 inches or so of the speaker cable jacket to expose the
positive and negative insulated wires.Strip 3/8-1/2 inch of insulation
off of these conductors.
Distance Gauge
<10 Feet 18
10-50 Feet 16
>50 Feet 14
Speaker Wire
Gauge Selection Chart
Figure 3
Figure 2
In-Ceiling Style
(
shown w/o
g
rill
)
In-Wall Style
(
shown w/o
g
rill
)
Figure 1


Produkt Specifikationer

Mærke: Legrand
Kategori: Speaker
Model: 364765-02

Har du brug for hjælp?

Hvis du har brug for hjælp til Legrand 364765-02 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Speaker Legrand Manualer

Legrand

Legrand 364765-02 Manual

16 August 2024

Speaker Manualer

Nyeste Speaker Manualer

Muse

Muse M-1928 DJ Manual

11 Oktober 2024
Muse

Muse M-1982 DJ Manual

11 Oktober 2024
AV:link

AV:link 129.200UK Manual

9 Oktober 2024
Muse

Muse M-930 DJN Manual

8 Oktober 2024
KEF

KEF T-2 Manual

8 Oktober 2024
Caliber

Caliber HSB513BTL Manual

8 Oktober 2024
LG

LG LM-D5531S Manual

7 Oktober 2024
JL Audio

JL Audio C1-690tx Manual

7 Oktober 2024
Sony

Sony SS-RX900 Manual

7 Oktober 2024
Musway

Musway ME6.2W Manual

7 Oktober 2024