Lenmar LAC916RSG Manual

Lenmar power bank LAC916RSG

Læs nedenfor 📖 manual på dansk for Lenmar LAC916RSG (1 sider) i kategorien power bank. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

Model PPU916RS

Lenmar PowerPort Laptop Battery – The Ultimate Power On The Go

Important Safety Instructions are included.

Please read the entire manual before use.

OWNER’S MANUAL

Thank you for purchasing the PPU916RS PowerPort Laptop Battery for notebook and laptop computers. The

PPU916RS provides a 16 & 19 VDC output that can provide up to 3 hours of additional runtime. Also included

is a USB output port for charging your cell phone, PDA, MP3 player or any other device that can be charged

from a standard USB port. Please note: This is not compatible with tablets.

PRE-OPERATION SETUP

Please make sure you follow the two steps outlined below to determine the right settings compatible with

your notebook or laptop computer.

Step 1. Determine Polarity

The PPU916RS works only with notebook and laptop computers that have “center positive” polarity. Please

confirm that your laptop has “center positive” polarity before using the PPU916RS. You may look for the

below in your notebook or laptop user manual (please see image to the right).

DO NOT USE the PPU916RS if your device shows “center negative” polarity.

Step 2: Determine Voltage Required

Please determine the required voltage needed for your

notebook or laptop computer. Once you have determined

the correct voltage, slide the switch on your PPU916RS

to either 16V or 19V.

In some cases you may determine the desired voltage is between whole numbers such as 18.5VDC. In this case

you would use the 19V setting. In the case of 20VDC, also choose the setting of 19VDC.

3.) Review the voltage indication marked next to

the input jack on the notebook or laptop

computer to be powered.

Example: VIN: = 16VDC or 16V DC

1.) Review the power or ID plate on the original

AC / DC power supply that comes with your

notebook or laptop computer. Look for the word

“DC RATING or OUTPUT” followed by a number

and VDC*.

Example: VIN: = 16VDC or 16V DC

2.) Review the power ID plate on your notebook or

laptop computer to be powered. This is usually

found on the bottom of your computer. Look

for the word “DC RATING or INPUT” followed by

a number and VDC*.

Example: DC RATING: 16VDC or INPUT: 16VDC

1. 2.

3. 4.

313-100-33-0410 r2 y1

OPERATING INSTRUCTIONS

The PPU916RS must be charged before initial use to power up your notebook or laptop computer.

*Note: The specific notation “VDC” might not be indicated. Instead the following international symbol

shown might be used 16 . In some cases you may determine the desired voltage is between whole

numbers such as 15.5VDC. In this case use the next higher voltage setting. For example, use 16VDC if

the desired voltage is 15.5VDC.

Select the adapter tips that correspond to your laptop or notebook brand and model by visiting

www.lenmar.com/adaptertips. Verify the fit of the power tip by plugging it into the input jack on your laptop.

It is important that the center contact or pin be the correct size to insure proper electrical contact. The tip

should slide in as easily as the original adapter tip. Do not force it. If it does not fit easily please verify that you

have the correct tip listed in our reference.

SELECTING THE RIGHT BATTERY TIP

The PPU916RS comes with 8 power tips, and 7 charging tips and one 30” power cord. These tips will

allow you to charge the PPU916RS and also power your laptop.

Determine the correct power tip and connect it to the included 30” power cord then plug it into your

laptop. The power tips consist of models L01D, L51D, L52D, L53D, L54D, L55D, L61D, and L62D. The

charging tips are made to connect to your existing AC Adaptor and then be plugged into the “IN” jack on

the PPU916RS. They are the right angle tips consisting of models: L01, L51, L53, L54, L55, L61 and L62. You

may also use your existing AC Adapter tip if it fits.

CHARGING THE PPU916RS

To charge the PPPU916RS, use your notebook or laptop

computer’s existing AC Adapter. Connect the AC Adapter

to the correct charging tip. Then plug in the tip into the

“IN” port of the PPU916RS. Approximate charge time is 5

hours. You will see an indicator on the 5th LED light. The

light will be red while charging and will turn blue once the

charge is complete.

CONNECTING THE PPU916RS TO YOUR LAPTOP

Plug the supplied 30” power cable into the “OUT” port on the PPU916RS. Attach the correct power tip to

the other end of the cable and plug this into the “DC IN” port of your laptop.

CAPACITY INDICATOR

Press the button on the top of the PPU916RS to show remaining capacity, there are 4 indicator lights.

USB POWER PORT

The PPU916RS has a built in USB port for the convenience of

charging your cell phone, PDA, MP3 player or any other

device that can be charged from a standard USB port. For

best results use an OEM or factory approved USB cable.

Please note: This is not compatible with tablets.

NOTICE

• Keep the PPU916RS dry, if it gets wet wipe it dry immediately.

• Use and store it in normal temperature environments.

• Handle the PPU916RS carefully, do not drop it. Do not use the PPU916RS if the cords become damaged.

• Keep the PPU916RS away from dust and dirt; wipe it with a cloth occasionally to keep it clean.

• There are no user serviceable parts inside! Modifying or tampering with its internal components can cause a

malfunction and will invalidate its warranty. If your PPU916RS is not performing as it should during the

warranty period, contact Lenmar for warranty service.

PPU916RS

OUTPUT CABLE

1 2 3 4 5BUTTON

LED

CHARGING

INDICATOR

OUTPUT TIP

SLIDING BUTTON BETWEEN 16V/19V SELECTION

LIMITED 1 YEAR WARRANTY

Lenmar product is warranted to be free of defective parts and workmanship for stated period from the

original date of purchase when sold through our website or our authorized retailers. Warranties are not

transferable. The warranty excludes damage resulting from accident, misuse, modication, delay or loss of

use, damage to equipment or by normal wear and tear.

ALL WARRANTY CLAIMS ARE PROCESSED ONLINE AT THE FOLLOWING LINK:

WWW.LENMAR.COM/WARRANTY

Warranty claims made after 60 days from the original date of purchase, will require a processing fee. Details

will be included while completing the online warranty request. Payment can be made via credit card when

completing the warranty form or a check can be included with the package when it is returned to Lenmar.

Once the request is completed, you will be emailed with a conrmation WRA number and instructions on how

to return the item for a warranty replacement.

Proposition 65 Notice (California)

The following statement is required in the state of California pursuant to the settlement of an action brought

by the Mateel Environmental Justice Foundation against multiple electronics and appliance manufacturers

• WARNING: Handling the cord on this product will expose you to lead, a chemical known to the

state of California to cause birth defects or other reproductive harm. Wash hands after handling.

Contact Lenmar Enterprises, Inc.

For more information about product compatibility and adapter tips, please go online and visit

www.lenmar.com/adaptertips.

For additional questions, comments, or to explore other Lenmar power solutions, visit our website at:

www.lenmar.com, email info@lenmar.com, or call 800-424-2703 between the hours of 9am-5pm PST.

PRODUCT SPECIFICATIONS

Chemistry: Lithium-Polymer

Charge input: 15V ~ 25 V 2.5A~ 4A adapter input

Discharge output: 5.3 V, 16V, 19V

CAPACITY

INDICATOR

AC ADAPTER LABEL

DC RATING:16V

BOTTOM OF LAPTOP

DC RATING:16V

SIDE OF LAPTOP

VIN: = 16VDC

CHARGING TIP

POWER TIP

L01D

L51D

L52D

L53D

L54D

L55D

L61D

L62D

L01

L51

L53

L54

L55

L61

L62

PPU916RS

CHARGE TIP

ORIGINAL NOTEBOOK AC ADAPTER

LED 1 indicates 0% to 25%

LED 2 indicates 25% to 50%

LED 3 indicates 40% to 60%

LED 4 indicates 75% to 100%

USB PORT

Lithium-Polymer battery must be

recycled or disposed of properly.

Charge time: Approx 5 hours.

Output WH: 61Wh / 5500mAh

CENTER POSITIVE

Produkt Specifikationer

Mærke:	Lenmar
Kategori:	power bank
Model:	LAC916RSG

Har du brug for hjælp?

Hvis du har brug for hjælp til Lenmar LAC916RSG stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

power bank Lenmar Manualer

Lenmar PowerPort Wave 5000 Manual

20 August 2024

Lenmar PowerPort Kit Manual

19 August 2024

Lenmar PowerPort Wave 2400 Manual

19 August 2024

Lenmar PowerPort Manual

18 August 2024

Lenmar LAC916RSG Manual

18 August 2024

Lenmar ACUSB31 Manual

18 August 2024

Lenmar PowerPort Slim Manual

18 August 2024

Lenmar PPW11000UG Manual

16 August 2024

power bank Manualer

Nyeste power bank Manualer

Bauhn ATAPB-0224 Manual

15 Oktober 2024

GoGen PB270001BL Manual

10 Oktober 2024

Einhell TE-CP 18 Li USB-Solo Manual

7 Oktober 2024

CyberPower CPBC10400 Manual

7 Oktober 2024

Fresh 'n Rebel 2PB3000CC Manual

7 Oktober 2024

Kogan KAPBCMPN50A Manual

1 Oktober 2024

Kogan KAPB05L20WA Manual

1 Oktober 2024

Voltcraft VC-C909 Manual

30 September 2024

Urban Factory BCA31UF Manual

30 September 2024

Urban Factory BCA35UF Manual

30 September 2024