Minute Man SSL-WATER Manual


Læs nedenfor 📖 manual på dansk for Minute Man SSL-WATER (1 sider) i kategorien Luftfugter. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
SSL-WATER User’s Manual
IMPORTANT: Read all of the instructions before
attempting to install the SSL-WATER leak sensor.
DESCRIPTION
The SSL-WATER sensor is a device, which connects with
SSL-EMD. When water permeates into the sensor cable, the
conductivity enhances the intensity of electric current and the
alarm will be triggered. Through the SNMP-SSL card, the use
r
can monitor it and receive notifications of the alarms. The
following cable type comes with the water leak sensor:
Type A: 1m water leak sensor connected to 1.2m cable
APPLICATION
Common usage are areas where mission-critical equipment is
being maintained, including data rooms, data centers, clean
rooms, utility corridors, laboratories, telecommunication
facilities, storage areas, elevator shafts, drip pans unde
r
wate
r
-cooled equipment, and many more. The most common
application for water leak detection is under raised floors. It is
common for water leak sensors to be installed under the
raised floor as well as in the ceiling above equipment.
Facilities and equipment that use water-cooled technology
have started to add water leak sensors to provide early
warning of water leaks. The water leak sensor is installed
around the supply and return water lines.
INSTALLATION
1. Loosen the screws on SSL-EMD.
2. Connect the wires of SSL-WATER sensor to the SSL-EMD
A
larm-1 and/or Alarm-2, and then tighten the screws.
3. Connect the straight-through CAT5 network cable from the
SNMP-SSL card’s RJ45 connector labeled “COM” to the
connector labeled “010101” on the SSL-EMD.
4. Verify that the SNMP-SSL card has a network connection and
is powered on.
5. Check the LED (Power/Status) of SSL-EMD, it will flash ever
y
5-seconds.
6. Open a Web browser and connect to the SNMP-SSL card.
7. Change the setting of “SSL-EMD Status” from “Disable” to
“Auto” on the EMD Configuration page.
8. Set the status of Alarm-1 and/or Alarm-2 to “Normal Open”.
9. Place the SSL-WATER sensor in the desired location.
10. The installation of the SSL-WATER sensor is complete. See
the SNMP
-
SSL User
s Manual.
LIMITED PRODUCT WARRANTY
Para Systems Inc. (Para Systems) warrants this equipment, when
properly applied and operated within specified conditions, against
faulty materials or workmanship for a period of three years from the
date of original purchase by the end user. For equipment sites within
the United States and Canada, this warranty covers repair o
r
replacement of defective equipment at the discretion of Para
Systems. Repair will be from the nearest authorized service center.
Replacement parts and warranty labor will be borne by Para Systems.
For equipment located outside of the United States and Canada, Para
Systems only covers faulty parts. Para Systems products repaired
or replaced pursuant to this warranty shall be warranted for the
remaining portion of the warranty that applies to the original product.
This warranty applies only to the original purchaser who must have
properly registered the product within 10 days of purchase.
The warranty shall be void if (a) the equipment is damaged by the
customer, is improperly used, is subjected to an adverse operating
environment, or is operated outside the limits of its electrical
specifications; (b) the equipment is repaired or modified by anyone
other than Para Systems or Para Systems-approved personnel; or (c)
has been used in a manner contrary to the product's operating
manual or other written instructions.
A
ny technical advice furnished before or after delivery in regard to use
or application of Para Systems’s equipment is furnished without
charge and on the basis that it represents Para Systems’s best
j
udgment under the circumstances, but it is used at the recipient's
sole risk.
EXCEPT AS PROVIDED HEREIN, PARA SYSTEMS MAKES NO
WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
PARTICULAR PURPOSE. Some states do not permit limitation o
f
implied warranties; therefore, the aforesaid limitation(s) may not appl
y
to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL PAR
A
SYSTEMS BE LIABLE FOR DIRECT, INDIRECT, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF
THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE. Specifically, Para Systems is
not liable for any costs, such as lost profits or revenue, loss o
f
equipment, loss of use of equipment, loss of software, loss of data,
cost of substitutes, claims by third parties, or otherwise. The sole
and exclusive remedy for breach of any warranty, expressed o
r
implied, concerning Para Systems’s products and the only obligation
of Para Systems hereunder, shall be the repair or replacement o
f
defective equipment, components, or parts; or, at Para Systems’s
option, refund of the purchase price or substitution with an equivalent
replacement product. This warranty gives you specific legal rights
and you may also have other rights, which vary from state to state.
OBTAINING TECHNICAL ASSISTANCE
Para Systems (Minuteman UPS) Technical Support:
Phone: 1-972-446-7363
Fax: 1-972-446-9011
Web: www.minutemanups.com/support/con_tech2.php
www.minutemanups.com © Copyright 2008 34000364 R1


Produkt Specifikationer

Mærke: Minute Man
Kategori: Luftfugter
Model: SSL-WATER

Har du brug for hjælp?

Hvis du har brug for hjælp til Minute Man SSL-WATER stil et spørgsmål nedenfor, og andre brugere vil svare dig




Luftfugter Minute Man Manualer

Luftfugter Manualer

Nyeste Luftfugter Manualer

Eldom

Eldom Amar NU50 Manual

16 November 2024
Medescan

Medescan WSV0124 Manual

6 November 2024
Scarlett

Scarlett SC-985 Manual

15 Oktober 2024
Master

Master DHA 250 Manual

10 Oktober 2024
Philips

Philips HU1509 Manual

7 Oktober 2024
Philips

Philips HU5710 Manual

7 Oktober 2024
Trotec

Trotec TTR 300 Manual

3 Oktober 2024