Miomare IAN 91554 Manual

Miomare Brusehoved IAN 91554

Læs nedenfor 📖 manual på dansk for Miomare IAN 91554 (4 sider) i kategorien Brusehoved. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
FR
GB/IE
service centre. The user will then receive a new or repaired hand shower free
of charge. After the guarantee period has expired you may also send a defec-
tive hand shower to the address provided for repairs.
Repairs made after the expiration of the warranty period are subject to payment.
This warranty does not limit your legal rights.
If you have any queries or faults with the product, please contact the following
Service address:
GB
Eisl Sanitär GmbH
Mattseer Landesstraße 8
A-5101 Bergheim
Tel.: 00800-87934629*
Tel.: +43-662-879346-29
Fax: 00800-87934650*
Fax: +43-662-879346-50
E-Mail: service@eisl.at
* Free of charge number
IE
Eisl Sanitär GmbH
Mattseer Landesstraße 8
A-5101 Bergheim
Tel.: 00800-87934629*
Tel.: +43-662-879346-29
Fax: +43-662-879346-50
E-Mail: service@eisl.at
* Free of charge number
IAN 91554
For all inquiries about your product, please have your receipt and the article
number (e.g. IAN 12345) ready as your proof of purchase.
Product description: Hand shower unit
Eisl sanitary No.: DX2013-LIDL
GB/IE
Hand-Held Shower Head
Introduction
We congratulate you on the purchase of your new hand shower unit.
You have selected a high-quality hand shower unit. The assembly and
operating instructions are part of this product. Please read these assem-
bly instructions and instructions for use thoroughly before use and observe all in-
structions. These assembly instructions and instructions for use contains important
assembly, set-up and maintenance information. Please retain these assembly in-
structions and instructions for use and hand them on to any future owner.
Intended use
This hand shower unit is solely intended for use when attached to a shower hose
that is, in turn connected with a bath tap or shower tap. Any use not specified
or product modification is prohibited and will result in damage. Any form of
use other than the stipulated intended purpose can cause danger to life and
cause injury. The product is for private use only and is not intended for medical
or commercial use. The manufacturer accepts no responsibility if the intended
purpose of this unit is not adhered to.
Parts description
1 Jet disc
2 Actuating lever
3 Hand shower unit
4 Washer*
5 Shower hose*
GB/IE GB/IEGB/IEGB/IE
*not included in delivery
Technical Data
Hand shower unit connector: G ½“
Minimum required water pressure: 1.5 bar
Flow at 3 bar: approx. 4-11 l / min, depending on jet variant and water
temperature.
Scope of delivery
1 Hand shower unit
1 Instructions for installation / operation
Safety information
DANGER TO LIFE AND RISK OF ACCI-
DENTS FOR INFANTS AND CHILDREN! Never leave
children unattended with the packaging material. Danger of suf-
focation. Keep this product well away from children. This product is not a toy.
BEWARE OF ELECTRIC SHOCK! Leaking or water discharge
can lead to life-threatening danger due to electric shock.
Please ensure that the stopcock for the tap is turned off.
ATTENTION when working on hand showers that already have a water
stop function.
Otherwise there is a danger of injury and / or damage to objects.
Installation
Warning: Get to know your product before assembly. Carefully read the
following assembly instructions and safety advice. In the event of incorrect in-
stallation, all warranty claims – particularly in relation to subsequent damage
– are excluded.
Please ensure that the stopcock for the tap is turned off.
ATTENTION when working on hand showers that already have a water
stop function.
Otherwise there is a danger of injury and / or damage to objects.
Follow these steps:
Unscrew your existing hand shower unit from the shower hose 5.
Double-check the washers 4 and seals in the connection piece of the
hose 5.
Now screw your new hand shower 3 attachment onto the shower hose 5.
Start-up
After the initial installation, carefully check all connections for leaks.
Check that your hand shower 3 is working correctly by setting the jet
lever 2 to every possible 1 position (see fig. C).
Operation
Warning: If your hand shower attachment has not been used for a while,
clean it in order to remove any water residue that may have built up.
Your new hand shower 3 has 5 different settings (see fig. B).
To change the water jet type, follow these steps:
Adjust to the desired water temperature and the desired water pressure
using your tap.
Turn the jet disc 1 using the operating lever 2 until it reaches the desired
marking ( ) symbol on the shower head 3 (see fig. C).
When showering sensitive areas of your body it may be advisable Note:
not to set the massage jet from your hand shower 3 to too high a power.
Maintenance and Cleaning
Please note that chromed surfaces require special care and attention. Therefore,
please follow the instructions:
Check the hand shower regularly for leakages
When cleaning, never use petrol, solvents, aggressive cleansers or hard
cleaning brushes etc. These could damage the surface of the product.
Dry your hand shower unit with a soft, damp cloth to hinder limescale
build-up.
Clean the product with a damp, soft cloth and a mild cleaning agent if
required.
Regularly rub the soft anti-limescale jets and remove any limescale that
may have built-up.
Failure to observe these instructions will cause damage to the surface of
the unit. This will inevitably invalidate the guarantee.
Disposal
The packaging is made of environmentally friendly materials, which
may be disposed through your local recycling facilities.
Contact your local refuse disposal authority for more details of how to dispose
of your worn-out product.
Quality of tap water
Find out about the potability of your mains water supply. Your local water
authority or water supply company will be able to inform you.
The following general recommendations apply to the potability of tap water:
Let the water run freely for a short time if it has been stagnating in the pipe-
work for more than four hours. Do not use any of this stagnant water in the
preparation of food or for drinking. This applies particularly as far as babies
and infants are concerned.
Failure to observe these instructions may have negative health effects.
Fresh water can be readily distinguished from stagnant water as fresh
water is noticeably cooler as it leaves the pipe.
Do not use stagnant water from chromium-plated pipework for the prepa-
ration of food or for drinking or for personal hygiene if you are allergic to
nickel. This water may contain high quantities of nickel and trigger an aller-
gic reaction.
Do not use water from lead pipework for preparing food or drink for ba-
bies or infants. Do not use it for preparing food or drink during pregnancy.
Lead dissolves in drinking water and is particularly damaging to the health
of babies and young children.
Guarantee and Service
The warranty period is three years and begins on the day of purchase. Please
keep your receipt as proof of purchase.
During the guarantee period, defective hand showers can be sent at the user‘s
own cost to the service address provided, following relevant contact with the
HAND-HELD SHOWER HEAD
IAN 91554
HAND-HELD SHOWER HEAD
Operation and Safety Notes
Foam jet/Schaumstrahl Rain jet/Regenstrahl Massage jet/
Massagestrahl
Foam and Rain mix jet/
Mischstrahl Schaum+Regen
Rain and Massage mix jet/
Mischstrahl Regen+Massage
BA
1
C
2
3
4
5
HANDBRAUSE
Bedienungs- und Sicherheitshinweise


Produkt Specifikationer

Mærke: Miomare
Kategori: Brusehoved
Model: IAN 91554

Har du brug for hjælp?

Hvis du har brug for hjælp til Miomare IAN 91554 stil et spørgsmål nedenfor, og andre brugere vil svare dig