Oricom Wake 'N' Shake Dynamite WNS80 Manual

Oricom Ikke kategoriseret Wake 'N' Shake Dynamite WNS80

Læs nedenfor 📖 manual på dansk for Oricom Wake 'N' Shake Dynamite WNS80 (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

1 32 4

INSTALLATION

Plug the supplied AC/DC adaptor (Model No. 2T0069) to an AC household outlet, and

then plug the DC jack to the back of the unit. Your clock is ready to work for you.

TO SET TIME AND THE SNOOZE DURATION

1. Press SET once, the hour digits “ ” ﬂash. Press or to set the time in hours (hold 0▲ ▼

to advance rapidly).

2. Press SET again, the minute digits “ ” ﬂash. Press or to set the time in minutes. 00 ▲ ▼

(hold to advance rapidly).

3. Press SET again, the display shows “ ” and ﬂashes. Press or to select 24Hr ▲ ▼

“12Hr” or “24Hr” time format. If “ ” is selected, the will appear on the upper 12Hr AM

left to indicate the morning time and will appear on the upper right to indicate the PM

afternoon.

4. Press SET again, the display shows “ ” and ﬂashes. Press or to select your 05 ▲ ▼

snooze time from 5 to 60 minutes.

5. Press again or if no key pressed for approx. 10 seconds to exit the setting mode.SET

TO SET THE ALARM

1. Press and hold appear and the alarm’s hour digits ﬂash. Press AL SET / AL STOP, AL

▲ ▼ or to set the alarm in hours. (Hold or to advance rapidly).▲ ▼

2. Press AL SET / AL STOP once again, the minute digits ﬂash. Press or to set the ▲ ▼

alarm in minutes. (Hold or to advance rapidly).▲ ▼

3. Press AL SET / AL STOP again, LED displays “HI” (vibration at HI level), press or ▲ ▼

to select “ ” (vibration at Lo level).LO

4. Press AL SET / AL STOP once again, LED displays “F-1 (ex. 800 Hz)” and ﬂash, press

▲ ▼ or to select the alarm tone (frequency) :

F-1 (low tone, 800 Hz),

F-2 (mid tone, 1 KHz),

F-3 (high tone, 1.5 KHz)

5. Press AL SET / AL STOP again, LED displays “ ” ( for the Low ringer level), press L1 ▲

or ▼ to select “L3” (for the high ringer level)

6. Press AL SET / AL STOP once again to exit the alarm setting, also if no buttons are

pressed for around 10 seconds this will also exit the alarm setting mode.

TO TURN ON/OFF AND SELECT THE ALARM MODE

1. At normal time display mode, press one at a time to activate the AL SET / AL STOP

alarm(s) and turn on corresponding alarm indicator(s) on the lower part of the display:

: only shaker activated

: both sound and shaker alarm activated

: both strobe light and shaker alarm activated

: strobe light, sound and shaker alarm activated

2. Press AL SET / AL STOP once more to turn off all the alarms, all , and

alarm indicators are turned off.

Note: To use the shaker alarm, please plug in the shaker plug to the back of the clock. If

user doesn’t want to use the shaker alarm, unplug the shaker plug from the clock.

TO STOP AND RESET THE ALARM TO COME ON THE NEXT DAY

When alarm is sounding, the corresponding alarm indicator ﬂashes. Press AL SET / AL

STOP once to stop the alarm and reset it to come on the following day. After that, the

corresponding alarm indicator stays on the display.

TO USE SNOOZE (default snooze duration is 5 minutes)

When the alarm is sounding, press once, the alarm will stop temporarily and the

corresponding alarm indicator will keep ﬂashing. The alarm will come on again after the

set snooze duration is over.

TO USE THE HI-MED-LO DIMMER (LED TIME DIGITS)

There is a 3-level brightness control for the LED clock display. Press to adjust

the brightness ( ) on the LED display. The brightness adjustment can only HI / MED / LO

be done when the brightness starts at position.HI

TO USE THE RING OF LED LIGHT

Press and hold button to turn on the ring of LED light, the brightness level of the

LED ring (Hi-Med-Lo) corresponds to the time display brightness (Hi-Med-Lo).

When the LED ring lights up, press button one at a time to adjust time display

brightness and LED ring brightness accordingly.

Press and hold button to turn off the ring of LED light. (The LCD dimmer

automatically adjusts after the RED LED light is switched off).

CHARGE YOUR MOBILE PHONE WITH USB PORT

Connect the charging cable of your mobile phone to the USB port at the back of the clock

and then connect the other end to the micro USB charging socket on your mobile phone.

The clock will charge the mobile phone automatically.

Note:

1. Make sure the cable supplied with your mobile phone is used for charging.

2. Make sure the adaptor supplied with this clock (5V 1.2A) is used to power it.

3. It is not possible to charge an iPad® or notepad from the USB socket on this clock.

4. When the alarms are sounding/active you can not charge phones etc using the USB

port.

TEST MODE

Press and hold button, strobe light ﬂashing, shaker vibrating and buzzer ▲/ TEST

sounding.

TROUBLE SHOOTING

Your clock may display the incorrect time or may not function correctly due to electro-static

discharge or other interference like an electrical surge when an electric timer or heater

switches on/off (poor mains ﬁltering). The mains adapter for the clock should only be

plugged into a mains wall socket, not a mains extension that is shared with electric heater

(or other high wattage equipment).

CARE OF YOUR PRODUCT

1. Place your clock on a stable surface, away from sources of direct sunlight or excessive

heat or moisture.

2. Protect your furniture when placing your unit on a natural wood and lacquered ﬁnish by

using a cloth or protective material between the unit and the furniture.

3. Clean your unit with a soft cloth moistened only with mild soap and water. Stronger

agents such as benzene, cleaners containing alcohol, thinners or similar materials can

damage the surface of the unit.

SPECIFICATIONS

Alarm duration : 1 hour

Snooze duration Adjustable : 5 to 60 minutes

Default settings

Time format 24 hour

Time 0:00

Alarm 6:00

Alarm and shaker level HI

Alarm sound frequency F-1

Alarm sound level L1 (low)

Snooze duration 05 (5 minutes)

Audible alarm : up to 95 dBA at 1m

Express Warranty (Australia)

This Express Warranty is provided by Oricom International Pty Ltd ABN 46 086 116 369,

Unit 1, 4 Sovereign Place, South Windsor NSW 2756, herein after referred to as “Oricom”.

Oricom warrants that the product is free from defects in materials or workmanship during

the Express Warranty Period. This Express Warranty does not extend to any product from

which the serial number has been removed or was purchased outside of Australia.

The beneﬁts of this Express Warranty are in addition to other rights and remedies you may

have under the Australian Consumer Law. Our goods come with guarantees that cannot

be excluded under the Australian Consumer Law. You are entitled to a replacement or

refund for a major failure and compensation for any other reasonably foreseeable loss or

damage. You are also entitled to have the goods repaired or replaced if the goods fail to

be of acceptable quality and the failure does not amount to a major failure. In the event

of a minor failure, Oricom reserves the right to choose to repair or replace the product.

The Express Warranty Period will be a period of 12 months beginning on the date of

purchase of the product evidenced by your dated sales receipt. You are required to provide

proof of purchase as a condition of receiving Express Warranty services.

You are entitled to a replacement product or repair of the product at our discretion

according to the terms and conditions of this document if your product is found to be

faulty within the Express Warranty Period. This Express Warranty extends to the original

purchaser only and is not transferable.

Products distributed by Oricom are manufactured using new materials or new and used

materials equivalent to new in performance and reliability. Spare parts may be new

or equivalent to new. Spare parts are warranted to be free from defects in material or

workmanship for thirty (30) days or for the remainder of the Express Warranty Period

of the Oricom branded product in which they are installed, whichever is longer. During

the Express Warranty Period, Oricom will where possible repair and if not replace the

faulty product or part thereof. All component parts removed under this Express Warranty

become the property of Oricom. In the unlikely event that your Oricom product has a

recurring failure, Oricom may always, subject to the Competition and Consumer Act 2010,

at its discretion, elect to provide you with a replacement product of its choosing that is at

least equivalent to your product in performance.

No change to the conditions of this Express Warranty is valid unless it is made in writing

and signed by an authorised representative of Oricom.

Oricom will not be liable under this Express Warranty, and to the extent permitted by law

will not be liable for any defect, loss, damage or injury arising out of or in connection

with a:

1. Failure by you to adhere to the warnings and follow the instructions set out in this user

guide for the proper installation and use of the product;

2. Willful misconduct or deliberate misuse by you of the product;

3. Any external cause beyond our control, including but not limited to power failure,

lightning or over voltage; or

4. Modiﬁcation to the product or services carried out on the product by anyone other than

Oricom or Oricom’s authorised service provider.

How to make a claim under your Express Warranty in Australia

Oricom has a simple warranty process for you to follow:

• Please call or email our Customer Support Team, 02 4574 8888 or support@oricom.

com.au.

• A Customer Support Team member will verify after troubleshooting with you if your product

qualiﬁes under warranty. If so, they will give you a Product Return Authorisation number.

• We will then email a Return Authorisation form and a Repair Notice (if necessary), together

with instructions on how to return the product for warranty service.

Please note that if a Customer Support Team member advises that your product does

not qualify for return, this warranty does not apply to your product. Products that are

authorised to be returned to Oricom in Australia must include all of the following:

• A completed Return Authorisation form

• A copy of your Proof of Purchase (please keep your original copy)

• The faulty product, including all accessories.

Send the approved returns to:

Oricom International Pty Ltd

Locked Bag 658

South Windsor NSW 2756 Australia

Please note that this Express Warranty excludes expenses incurred by you in returning

any faulty product to us. You must arrange and pay any expenses incurred (including

postage, delivery, freight, transportation or insurance of the product) to return the faulty

product to us, however, p1-we will arrange delivery of the repaired or replaced faulty produc

to you.

Important Information

Repair Notice

Please be aware that the repair of your products may result in the loss of any user-

generated data (such as stored telephone numbers, text messages and contact

information). Please ensure that you have made a copy of any data saved on your product

before sending for repair. Please also be aware that products presented for repair may

be replaced by refurbished products or parts of the same type rather than being repaired.

Ref: 24062022

WNS80 USER GUIDE

KEEP THIS USER GUIDE FOR FUTURE REFERENCE

Always retain your proof of purchase in case of warranty service.

AUSTRALIA: www.oricom.com.au

ALARM

TIME

WAKE-T

BUZZ

AKE-T

O-

VIBR IAT

AKE-TO

LASHING LE

TEST

ALARM

HAKE

USB charging cable

(not included)

ADAPTOR

(Model No.

0069

)

Produkt Specifikationer

Mærke:	Oricom
Kategori:	Ikke kategoriseret
Model:	Wake 'N' Shake Dynamite WNS80

Har du brug for hjælp?

Hvis du har brug for hjælp til Oricom Wake 'N' Shake Dynamite WNS80 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Oricom Manualer

Oricom Eclipse OBHSSOO Manual

19 August 2024

18 August 2024

16 August 2024

14 August 2024

13 August 2024

Oricom WAKE'N' SHAKE WNS10 Manual

12 August 2024

Oricom VISO10 Manual

12 August 2024

Oricom Wake 'N' Shake Dynamite WNS80 Manual

12 August 2024

Oricom OBHAD200 Manual

12 August 2024

Oricom HNA100 Manual

11 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

SoundTube IPD-RS82-EZ Manual

26 November 2024

Kramer 4x1VB Manual

26 November 2024

Kramer RC-63A Manual

26 November 2024

SoundTube IPD-HP82-EZ Manual

26 November 2024

Kramer RK-KVM-1U-PP3 Manual

26 November 2024

Gioteck VX-2 (PS3) Manual

26 November 2024

AOpen DE3650-C Manual

26 November 2024

Lazer Urbanize MIPS Manual

26 November 2024

Symmons Dia 353GB-24 Manual

26 November 2024

SoundTube IPD-RS62-EZ Manual

26 November 2024