Planet POE-E304 Manual

Planet Wifi repeater POE-E304

Læs nedenfor 📖 manual på dansk for Planet POE-E304 (4 sider) i kategorien Wifi repeater. Denne guide var nyttig for 11 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/4
- 1 -
- 2 -
- 3 -
- 4 -
- 5 -
- 6 -
- 7 -
- 8 -
1. Package Contents
Thank you for purchasing PLANET 1-port Ultra PoE+ to 4-port IEEE
802.3af/at Gigabit PoE Extender, POE-E304. “Gigabit PoE Extender”
mentioned in this manual refers to the POE-E304.
Open the box of the Gigabit PoE Extender and carefully unpack it. The
box should contain the following items:
Gigabit PoE Extender x 1 User’s Manual x 1
Rubber Feet x 4 Wall-mount Kit
If any of these are missing or damaged, please contact your dealer
immediately; if possible, retain the carton including the original packing
material, and use them again to repack the product in case there is a
need to return it to us for repair.
Features Store-and-Forward mode with wire-speed ltering and
forwarding rates
IEEE 802.3x ow control for full duplex operation and backpressure
for half duplex operation
Automatic address learning and address aging
Case and Installation
No external power cable installation required
Made of metal, desktop size design
Wall-mountable, Plug-and-Play installation
0 ~ 50 degrees C operating Temperature
Note
PSE (Power Sourcing Equipment) is a device (switch
or hub for instance) that will provide power in a PoE
setup. The maximum allowed continuous output power
per such device in IEEE 802.3af is 15.4 watts and in IEEE
802.3at is 30 watts.
PD (Powered Device) such as IP phones, network
cameras or wireless access points is a PoE-enabled
terminal that consumes energy supplied by PSE.
4. Hardware Introduction
4.1 Three-View Diagram
The three-view diagram of the Gigabit PoE Extender consists of one
auto-sensing 10/100/1000BASE-T Ultra PoE In port, and four auto-
sensing 10/100/1000BASE-T 802.3af/802.3at PoE Out ports. The LED
Indicators are also located on the port of Gigabit PoE Extender front
panel.
PoE In-Use
PoE MAX
PWR
1 2 3 4
541 2
PoE OUT PoE IN
3
10/100
1000
LNK ACT
Figure 1: POE-E304
Protection ESD (Ethernet): 6KV
Surge (EFT for power): 2KV
Enclosure Metal
Installation Desktop/Wall mountable
Dimensions
(W x D x H) 160 x 92.5 x 28mm
Weight 370g
Power
Requirements
PoE In: IEEE 802.3bt or 4-pair 802.3at PoE+
compliant with voltage within 50V-56V DC
External DC: 50~56V DC
Power
Consumption
4 watts/13.7BTU (System on with PoE input)
6 watts/20.6BTU (Ethernet full loading without PoE
function)
60 watts/205.9BTU (Full loading with PoE function)
Network Cable
10BASE-T: 4-pair UTP Cat5 up to 100m (328ft)
100BASE-TX: 4-pair UTP Cat5 up to 100m (328ft)
1000BASE-T: 4-pair UTP Cat5e, 6, up to 100m
(328ft)
EIA/TIA-568 100-ohm STP (100m, 328ft)
Power over Ethernet
PoE Standard
PoE In Port
Ultra Power over Ethernet end-span/mid-span PD
class 4 PD
Per PoE Out Port
IEEE 802.3at Power over Ethernet Plus end-span
PSE
IEEE 802.3af Power over Ethernet end-span PSE
2. Product Features
Physical Port
5-port 10/100/1000BASE-T Gigabit RJ45 interface
- 1-port data + power input
- 4-port data + power output
Power over Ethernet
1-port data + power input
- Complies with Ultra Power over Ethernet end-span/mid-span PD
- Supports PoE input power up to 60 watts
4-port data + power output
- Complies with IEEE 802.3af/IEEE 802.3at Power over Ethernet/
end-span PSE
- Up to 4 IEEE 802.3af/802.3at devices powered
- Supports PoE power up to 30.8 watts for each PoE port
- Auto detects powered device (PD)
Extends the range of PoE to an additional 100 meters (328ft.)
Forwards both Ethernet data and PoE power to remote device
Layer 2 Features
Hardware based 10/100/1000Mbps auto-negotiation and auto MDI/
MDI-X
Integrates address look-up engine, supporting 2K absolute MAC
addresses
9K Jumbo packet support
IEEE 802.1Q VLAN transparency
PoE Power
PoE In Port
50~56V DC, max. 60 watts
Per PoE Out Port
44~55V DC, max. 30.8 watts
Power Pin
Assignment
PoE In Port
1/2 (+), 3/6 (-); 4/5 (+), 7/8 (-) or 1/2(-), 3/6(+);
4/5(+), 7/8(-)
Per PoE Out Port
1/2 (+), 3/6 (-), end-span (Type A)
PoE Power
Budget
50 watts (max.) @ Ultra PoE input
20 watts (max.) @ IEEE 802.3at PoE+ input
Standard Conformance
Regulatory
Compliance FCC Part 15 Class A, CE
Standard
Compliance
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3ab 1000BASE-T Gigabit Ethernet
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet Plus
IEEE 802.3x Flow Control
Environment
Operating Temperature: 0 ~ 50 degrees C
Relative Humidity: 5 ~ 95% (non-condensing)
Storage Temperature: -10 ~ 70 degrees C
Relative Humidity: 5 ~ 95% (non-condensing)
Note
The maximum distance that data and power can transmit
depends on the quality of the UTP cable and environment.
4.2 Ports Connection
PoE IN Port
Connect the port from the following Ultra PoE IN PSE
devices through a Cat5/5e/6 UTP cable:
Ultra PoE injector
Ultra PoE injector hub
Ultra PoE Ethernet switch
PoE OUT Port
Connect the port to the following 802.3at/af PoE OUT
PD devices through a Cat5/5e/6 UTP cable:
PoE IP camera
PoE VoIP phone
PoE wireless AP
PoE splitter
4.3 LED Indicators
Ultra PoE IN Port
LED Color Function
10/100 LNK/
ACT Orange
Lights to indicate the link through that port is
successfully established at 1000Mbps.
Blinks to indicate that the port is actively
sending or receiving data.
1000
LNK/ACT Green
Lights to indicate the link through that port is
successfully established at 1000Mbps.
Blinks to indicate that the port is actively
sending or receiving data.
3.ProductSpecications
Model POE-E304
Hardware Specications
Network
Connector
PoE In Port
1 x 10/100/1000BASE-T Ethernet with Ultra PoE
b in, auto MDI/MDI-X, auto-negotiation RJ45
connector
PoE Out Port
4 x 10/100/1000BASE-T Ethernet with IEEE
802.3at/802.3af PoE out, auto MDI/“Data + DC”
MDI-X, auto-negotiation RJ45 connector
Data Rate 10/100/1000Mbps
Switch
Architecture Store-and-Forward
MAC Address
Table 2K
Data Buffer 2Mbits
Switch Fabric 10Gbps
Switch
Throughput 7.44Mpps @ 64 bytes
Jumbo Frame 9K
Flow Control IEEE 802.3x pause frame for full duplex
Back pressure for half duplex
LED Indicators
PoE In Port
10/100 LNK/ACT ( ), 1000 LNK/ACT (orange green)
PoE Out Port 1 to Port 4
10/100 LNK/ACT ( ), 1000 LNK/ACT (orange green)
PoE-in-Use (orange)
PoE Max. (orange)

Produkt Specifikationer

Mærke: Planet
Kategori: Wifi repeater
Model: POE-E304

Har du brug for hjælp?

Hvis du har brug for hjælp til Planet POE-E304 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Wifi repeater Planet Manualer

Planet

Planet POE-E201 Manual

21 September 2024
Planet

Planet WRE-1200-EU Manual

28 Juli 2024
Planet

Planet POE-E304 Manual

22 Juli 2024
Planet

Planet GRT-401 Manual

20 November 2023
Planet

Planet POE-E101 Manual

16 Februar 2023
Planet

Planet VC-234G Manual

25 December 2022
Planet

Planet IVC-2004PT Manual

16 November 2022
Planet

Planet VC-231G Manual

12 Oktober 2022

Wifi repeater Manualer

Nyeste Wifi repeater Manualer

Ubiquiti Networks

Ubiquiti Networks PBE-5AC-620 Manual

22 September 2024
Sitecom

Sitecom WLX-2001 Manual

22 September 2024
Netgear

Netgear SRS60 Manual

17 September 2024
Netgear

Netgear Nighthawk EAX20 Manual

15 September 2024
Digitus

Digitus DA-70141 Manual

12 September 2024
Heden

Heden ACCHRW300M Manual

8 September 2024
Cudy

Cudy RE3000 Manual

6 September 2024
Cudy

Cudy RE1200 Manual

6 September 2024
Extron

Extron FOX 3G HD-SDI SM Manual

5 September 2024
Extron

Extron FOXBOX Rx VGA MM Manual

5 September 2024