Quoizel Dury RDY1717AWH Manual

Quoizel Lys Dury RDY1717AWH

Læs nedenfor 📖 manual på dansk for Quoizel Dury RDY1717AWH (2 sider) i kategorien Lys. Denne guide var nyttig for 30 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
1of2
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
2018 QuoizelInc.
Assembly Instruction Sheet #IS-RDY1717AWH
For Style RDY1717AWH
ReleasedDate:2018-01-31
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Please go to for product cleaning tips. Go to the selection.
(4) B10 Candelabra Base bulbs 60W Maximum.
30-45 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
www.quoizel.com Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
A
Crossbar
Assembly
x 1
B
Fixture
Body
x 1
C
Ceiling Canopy
with Nipple
x 1
D
Spacer Tube
x 1
STEP 1 Install Spacer Tube and Ceiling Canopy-
A. Pass the supply wires and ground wire from fixture through the
Spacer Tube (C) and the Ceiling Canopy with Nipple (B) in turn.
Place the nipple of the Ceiling Canopy with Nipple (B) through the
Spacer Tube (C) and thread the nipple onto the hex coupling on the
top center of the Fixture Body (D). Hand tighten until snug.
Figure 1
STEP 2 -Installing the Crossbar Assembly
A. Pass the supply wires with ground wire from outlet box through the
Crossbar Assembly (A). Attach the Crossbar Assembly (A) to the
Outlet Box with the head of the Green Ground Screw facing you.
Secure the Crossbar Assembly (A) with Outlet Box Screws (not
included). Tighten until snug.
Supply Wires
with Ground Wire
Figure 2
B
C
D
Hex Coupling
Outlet Box Screws
(not included)
Outlet Box
A
Supply Wires
with Ground Wire
STEP 3 -Test Fit the Ceiling Canopy to the Crossbar Assembly
A. Remove the mounting balls from the Crossbar Assembly (A). Place
the ceiling canopy onto the Crossbar Assembly (A) and secure with
mounting balls. Note: The ceiling canopy should be snug against the
ceiling and held tight with the mounting balls. If it is not, adjust the
length of the mounting screws on the Crossbar Assembly (A) by
unscrewing the preassembled hex nut and lock washer and then
screwing the mounting screws in or out of the crossbar until the
correct length is achieved. Once the ceiling canopy is secure,
remove the mounting ball and fixture and proceed to Step 4.
Mounting Screw
Hex Nut and
Lock Washer
Mounting Ball
A
Figure 3
Ceiling Canopy


Produkt Specifikationer

Mærke: Quoizel
Kategori: Lys
Model: Dury RDY1717AWH

Har du brug for hjælp?

Hvis du har brug for hjælp til Quoizel Dury RDY1717AWH stil et spørgsmål nedenfor, og andre brugere vil svare dig




Lys Quoizel Manualer

Lys Manualer

Nyeste Lys Manualer

Nanlite

Nanlite D672BII Manual

19 December 2024
Nanlite

Nanlite Compac 40 Manual

19 December 2024
Nanlite

Nanlite MixPad II 11C Manual

18 December 2024
Nanlite

Nanlite D672II Manual

18 December 2024
Chauvet

Chauvet WELL POD 2X6 Manual

17 December 2024
Luxli

Luxli ORC-VIOLA-M2 Manual

17 December 2024
Makita

Makita DML817 Manual

16 December 2024
Makita

Makita MT001 Manual

16 December 2024