Sony SS-B3000 Manual

Sony Højttaler SS-B3000

Læs nedenfor 📖 manual på dansk for Sony SS-B3000 (2 sider) i kategorien Højttaler. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

English

 2007 Sony Corporation Printed in Malaysia

SPEAKER

–

Connections

• Before connecting, turn off the amplifier or receiver to

avoid damaging the speaker system.

• This speaker system is driven best by an amplifier or

receiver rated as per the wattage indicated in the

specification section.

A low-powered amplifier or receiver could result in

signal clipping, which could result in tweeter burn-out.

Therefore, it is recommended to use an amplifier or

receiver with sufficient power rating.

Note

Avoid driving the speaker system continuously with a

wattage exceeding the maximum input power of each

speaker.

Precautions

• Do not attempt to open the enclosure or remove

speaker units. There are no user-serviceable parts

inside.

• Keep recorded tapes, watches, and personal credit

cards using magnetic coding away from the speaker

system.

• Periodically wipe the cabinet with a soft cloth. Do not

use any type of scouring powder, abrasive pad or

solvent.

• Be sure to install the grill net in the correct direction.

Speaker Placement

Please note that room acoustics can often produce large

difference in the sound for small changes in speaker

placement.

• Set up your speaker system on a hard, flat place.

• Place the speaker system against a hard wall with its

back about 10 cm (4 in.) away from a wall. The

proportion of bass increases as you move a speaker

close to intersecting room surfaces (wall and wall, etc.).

• Place the right and left speakers in a similar acoustic

environment.

• It is recommended that the speaker/listener

relationship be an equilateral triangle.

Specifications

SS-B3000

Speaker system 3-way, magnetically shielded

Speaker units Woofer: 20 cm (8 in.) , cone type

Midrange: 8 cm (3 1/4 in.), cone type

Tweeter: 2.5 cm (1 in.) , balanced dome

type

Enclosure type Bass reflex

Rated impedance 8 ohms

Power handling capacity

Maximum input power: 120 watts

Sensitivity level 88 dB (1 W, 1 m)

Frequency range 50 Hz - 50,000 Hz

Dimensions (w/h/d) Approx. 240 × 530 263 mm×

(9 1/2 20 ×7/8 10 ×3/8 in.) including

front grille

Mass Approx. 6.5 kg (14 lb 6 oz)

Supplied accessory Speaker cord (2)

SS-B1000

Speaker system 2-way, magnetically shielded

Speaker units Woofer: 13 cm (5 1/8 in.) , cone type

Tweeter: 2.5 cm (1 in.) , balanced dome

type

Enclosure type Bass reflex

Rated impedance 8 ohms

Power handling capacity

Maximum input power: 120 watts

Sensitivity level 87 dB (1 W, 1 m)

Frequency range 80 Hz - 50,000 Hz

Dimensions (w/h/d) Approx. 170 × 255 186 mm×

(6 3/4 10 7 × × 3/8 in.) including front

grille

Mass Approx. 2.9 kg (6 lb 7 oz)

Supplied accessory Speaker cord (2)

Design and specifications are subject to change without

notice.

Standard Connection

Right Left

Amplifier

Speaker System

2-899-024-11(2)

SS-B3000/B1000

Owner’s Record

The model and serial numbers are located on the rear of the unit. Record the

serial number in the space provided below. Refer to them whenever you call

upon your Sony dealer regarding this product.

Model No. Serial No.

(2)

Produkt Specifikationer

Mærke:	Sony
Kategori:	Højttaler
Model:	SS-B3000
Bredde:	240 mm
Dybde:	263 mm
Højde:	530 mm
Vægt:	6500 g
Brugervejledning:	Ja
Produktfarve:	Sort
Udgangseffekt (RMS):	- W
Anbefalet brug:	Universel
Frekvensområde:	50 - 50000 Hz
Impedens:	8 ohm (Ω)
Forbindelsesteknologi:	Ledningsført
Højttaler, type:	3-vejs
Lyd-output kanaler:	2.0 kanaler
Højttaler, placering:	Bordplade/bogreol
Diskanthøjttaler:	Ja
Sensitivitet:	88 dB
Diskant diameter:	1 "
Bashøjttaler:	Ja
Woofer diameter:	200 mm
Forstærker:	Indbygget
Mid-range driver diameter:	80 mm
Woofer diameter (britisk mål):	8 "
Mid-range driver diameter (britisk mål):	3 "
Egnet til udendørs brug:	Ingen