Summit RHW20 Manual

Summit Emhætte RHW20

Læs nedenfor 📖 manual på dansk for Summit RHW20 (4 sider) i kategorien Emhætte. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/4

INSTALLATION INSTRUCTIONS

READ AND SAVE

Summit Appliance Range Hoods

THESE INSTRUCTIONS

Warning: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT USE THIS FAN WITH ANY

SOLID- STATE SPEED CONTROL.

Warning: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE

FOLLOWING:

A. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.

B. Before servicing or cleaning the unit, switch power to “OFF” at the service panel and lock the service, disconnecting means to prevent power from

being switched on accidentally. When service-disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag

to service panel.

Caution: For general ventilation only. Do not use to exhaust hazardous or explosive material or vapors.

Warning: TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

A. Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillover that may ignite. Heat oils slowly on low /

medium settings.

B. Always turn ON when cooking at high heat or when ambeing foods (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambe’).

C. Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or lter.

D. Use proper pan size. Always use cookware appropriate for the size of the surface element.

Warning: TO REDUCE THE RISK OF INJURY TO PERSON IN THE EVENT OF A RANGE TOP GREASE FIRE,

OBSERVE THE FOLLOWING:

A. SMOTHER FLAME with a close tting lid, cookie sheet or metal tray, then turn burner o. BE CAREFUL TO PREVENT BURNS. IF the ames

do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.

B. NEVER PICK UP A FLAMING PAN. YOU MAY GET BURNED!

C. including wet dish clothes and towels; a violent steam explosion will result.DO NOT USE WATER,

D. Use extinguisher, ONLY if:

1. You know you have a class ABC extinguisher, and you know how to operate it.

2. The re is small and contained in the area where it started.

3. The re department is being called.

4. You can ght the re with your back to an exit!

Warning: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSON, OBSERVE THE

FOLLOWING:

A. Installation work and electrical wiring must be done by qualied person(s) in accordance with all applicable codes and standards, including re-

rated construction codes and standards.

B. Sucient air is needed for proper combustion and exhausting of gases through the ue (chimney) of fuel burning equipment to prevent back

drafting. Follow the heating equipment manufacturer’s guideline and safety standards, such as those published by the National Fire Protection

Association (NFPA), and the American Society for Heating, Refrigeration, and Air Condition Engineers (ASHRAE) and the local code authorities.

C. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

D. Ducted fans must always be vented to the outdoors.

Warning: TO REDUC TH RISK OF FIRE, U METAL DUCTWORK ONLY! E E SE

Caution: T avoid re, electrical hock, or njury turn o circuit breaker to power upply re servicing. Switches e the rocker tyle switches. o s i , s befo ar s

The light switch is an “ON”, “OFF” witch. The motor witch, also a rocker tyle, is a 2-speed switc with a “LOW PEED” to the left and “HIGH s s s h S

SPEED” to the right. The aluminum lter hould be removed frequently washed in hot detergent water. Rinse in clear, warm water and shake o  s and

excess oisture before replacing. The charcoal lter hould not be washed, but may wiped o periodically with a damp cloth. This lter hould be m  s be  s

replaced every ix onths! In cleaning, never e scouring powder r teel , as s ill ar the nish. Remove lter and motor sembly s m us o s wool pads thi w m as

for equent cleaning. Clean entire hood and lter with hot water d mild household detergent. Exercise care when using cleaning agents fr an or

detergents of the fan. All done by due to possible deterioration of electrical components repair should be work qualied personnel. Should

replacement parts be required refer to the ood model and appropriate part number all hoods hnumber in correspondence. Range are either ducted or

ductless. Ducted with aluminum a round, rectangular, or 500 EZV, 1600EZV). Ductless oods hoods, lter come with either EZV models (1200, 1600, h

with charcoal lters are re-circulating models (500 require outside venting. When venting to the outside, EZV, 1600 EZV, or oods 1700). Ducted h

make sure the duct run is to avoid the use of elbows Use duct tape on all as short as possible. Try in the duct run. joints! Do not use a duct smaller