Vimar 01985.120 Manual

Vimar Lysdæmper 01985.120

Læs nedenfor 📖 manual på dansk for Vimar 01985.120 (1 sider) i kategorien Lysdæmper. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Viale Vicenza, 14 - 36063 Marostica VI Italy
Tel. +39 0424 488 600 - Fax (Italia) +39 0424 488 188 - Fax (Export) +39 0424 488 709
www.vimar.com
MASTER dimmer 120 V~ 60 Hz for incandescent lamps 40-500 W electronic
transformers 40-300 VA, CFL lamps 10-200 W, LED lamps 3-200 W, for LED
electronic power supplies, protection fuse, installation on DIN rails (60715
TH35), occupies 4 modules size 17.5 mm. For nautical scope.
ON/OFF switch and adjustment with two built-in buttons. MOSFET+TRIAC microprocessor
technology, works in both LE (Leading Edge) and TE (Trailing Edge) modes. MASTER function,
protection fuse. The device receives commands directly from the Busbar and is able to control
the load directly. It can also control up to 3 SLAVE dimmers for DIN rails 01986.120.
IMPORTANT: Lamps controllable from a single master or slave dimmer must all be the
same. All controllable loads must be declared DIMMERABLE by the manufacturer. Check
the type of compatible dimmering on the lamp package: LE (Leading Edge) or TE (Trailing
Edge). If it is not specified, the lamp can operate in both modes (chosen at the discretion
of the installer).
CHARACTERISTICS.
• RatedsupplyvoltageTPBusbar:29V
• Ratedsupplyvoltagemains:120V~,60Hz
• AbsorptionfromTPBusbar:15mA
• Dissipatedpower:7.8W
• Terminals:N neutral, load, phase, L Ssynchronization,TPBusbar
• ProtectionfusetypeF5AH250V
• Functionsthatcanbeaccomplishedwiththedimmer:
- Switching on, off and dimmering
- Changing absolute brightness
- Actuating/saving scenarios
- Enabling "Flash Start" mode for CFL lamps
- "Ramp" operation
- Switch-off delay and warning function
-Phasecutting:LE/TE
• Localcontrols:
Pressingthe button enables using the local buttons. All messages from the busbar are
ignored.
- Briefly pressing the button :ONcontrol
- Briefly pressing the button :OFFcontrol
-Pressingandholdingdownthebutton :Increasebrightness
-Pressingandholdingdownthebutton :Decreasebrightness
In normal operation (that is when the commands are sent over the bus) pressing the buttons
for the outputs is ignored.
• Protectionagainstshort-circuitingwhenturningonwithflashingblow-outindicator.
• Thermalprotectionwithflashingblow-outindicator.
• MASTER-SLAVE function: paying attention not to exceed maximum power controllable by
each dimmer. A MASTER device can have up to 3 SLAVE dimmers (art. 01986.120) for a
maximumtotalload of2000W(VA)correspondingto500W/VAmax connectedtoeachof
the 4 devices.
• InstallationonDINrails(60715TH35),occupies4modulesof17.5mm.
CONFIGURATION.
FOR THE OPERATIONS OF INSTALLATION AND CONFIGURATION, SEE THE BY-ME
SYSTEM INSTRUCTIONS MANUAL ATTACHED TO THE CONTROL PANEL.
Functionalunits:1;theunitcanbelongtoatmost4differentgroups.
• Selecting the functional unit (configuration): during group creation, when the control panel
requirespressingthedevicebutton:
-ItisrecommendedtoconfigurethedevicewiththeloadOFF;
-PresstheCONFbutton,theredLEDwilllightup;
- With the red LED on, the control panel will configure the functional unit; at the end of this
operation the red LED will go out.
Controllable loads LE TE
40 to 500 W 40 to 300 W
10 to 100 W 10 to 200 W(Max5lamps) (Max 10 lamps)
3 to 100 W 3 to 200 W(Max5lamps) (Max 10 lamps)
Electronic transformers
for halogen lamps
40 to 300 W
(Max 3 transformers type
L
)
40 to 300 W
(Max5transformerstype
C
)
Dimmering with Leading Edge mode Dimmering with Trailing Edge mode
INSTALLATION RULES.
Installation should be carried out in compliance with the current regulations regarding the instal-
lation of electrical systems in the country where the products are installed.
• Itshouldbeusedinplacesatatemperatureofbetween-5°Cand+45°C.
• Thelampsconnectedtothemasterorslavemustallbethesame.
• Notsuitableforcontrollingmotors(e.g.fans,ventilators).
Theratedpowerlevelshouldneverbeexceeded.
• Overloading, power surges and short-circuits may irreparably damage dimmers. Before
installation check the circuit carefully and eliminate any of the above causes.
• The dimmer does not have a mechanical circuit breaker in the main circuit and so is not
galvanically separated. The circuit load should be considered always powered.
For further instructions see the manual enclosed with the control panel.
CONFORMITY TO STANDARDS.
For MARINE use,thisdevicehasbeensubmittedtothefollowingtests:
IEC60068-2-52-TestKb:Saltmist,cyclic(sodium,chloridesolution),
IEC60068-2-6-TestFc:Vibration(sinusoidal)
Thisdevicecomplieswithpart15oftheFCC Rules (with the limits for a Class B digital device).
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesidered operation.
FRONT VIEW
CONNECTIONS
MaximumlengthofcablesconnectinguniversalMASTERdimmeranduniversalSLAVEdimmer:100m
Connect at least the minimum load required to the universal master dimmer.
A:IndicatorLED
B:Switchingonandincreasingbrightness
C:Switchingoffanddecreasingbrightness
D:LEDandconfigurationbutton
CHANGING FUSE
OFF
1.
01985.120
MASTER DIMMER
120V~
60Hz
40-50 0W LE
40-300W T E
CONF.
NLS
By-me
NLS
BUS
NLS
2.
01986.12001985.120 01986.120
N L S
TE Flash
Soft
LE
01986.120
SLAVE
DIMMER
40-500W LE
40-300W TE
120 V~ 60 Hz
N L S
TE Flash
Soft
LE
01986.120
SLAVE
DIMMER
40-500W LE
40-300W TE
120 V~ 60 Hz
N L S
01985.120
MASTER DIMMER
120 V~ 60 Hz
40-500W LE
40-300W TE
L
N
Bus
MASTER SLAVE SLAVE
A
B
C
D
BUS TP
LN
S
N L S
01985.120
MASTER DIMMER
120 V~ 60 Hz
40-500W LE
40-300W TE
01985.120
49400502A0011309
VIMAR - Marostica - Italy


Produkt Specifikationer

Mærke: Vimar
Kategori: Lysdæmper
Model: 01985.120

Har du brug for hjælp?

Hvis du har brug for hjælp til Vimar 01985.120 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Lysdæmper Vimar Manualer

Vimar

Vimar 20175 Manual

15 December 2024
Vimar

Vimar 19147 Manual

15 December 2024
Vimar

Vimar 19595.0 Manual

15 December 2024
Vimar

Vimar 16603.120.B Manual

15 December 2024
Vimar

Vimar 16604 Manual

15 December 2024
Vimar

Vimar 16609 Manual

15 December 2024
Vimar

Vimar 16625.B Manual

15 December 2024
Vimar

Vimar 16604.120.B Manual

15 December 2024
Vimar

Vimar 16601.B Manual

15 December 2024
Vimar

Vimar 16604.B Manual

15 December 2024

Lysdæmper Manualer

Nyeste Lysdæmper Manualer

Hager

Hager TYA662AN Manual

9 December 2024
Elro

Elro HE805S Manual

21 September 2024
ABB

ABB 2210UJ-214 Manual

14 September 2024
DiO

DiO 54767 Manual

12 September 2024
Ltech

Ltech CHLSC52 Manual

5 September 2024
Ltech

Ltech CHLSC39TX Manual

5 September 2024
Ltech

Ltech CHLSC41TX Manual

5 September 2024
Ltech

Ltech CHLSC20TX Manual

5 September 2024
Ltech

Ltech CHLSC50 Manual

5 September 2024