Zephyr RC-0001 Manual

Zephyr Controller RC-0001

Læs nedenfor 📖 manual på dansk for Zephyr RC-0001 (2 sider) i kategorien Controller. Denne guide var nyttig for 11 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
RC-0001 DCBL Remote Installation Instructions
2277 Harbor Bay Pkwy
1.888.880.8368
Alameda, CA 94502
1. Locate Main PC Board on top of blower
housing of hood body. Remove (4) Main
PC Board cover screws.
2. Remove Main PC Board from PC Board box. Use
caution when removing Main PC Board as to not
disconnect any wires
4. Install Remote Module into Main PC
Board box by (2) screws.
5. Re-install Main PC Board into PC Board box.
Be sure blue antenna wire from Remote Module
is outside of PC Board box. Turn to page
2 for remote synchronization & features.
CAUTION: Hood must be disconnected from main power prior to performing the conversion
instructions listed below. Failure to do so could result in personal injury or damage the hood.
!
Inclided Materials: 1 Remote Module w/antenna
wire, 1 Remote control, 1 Remote control holder,
1 battery, 2 screws.
Page 1
3. Disconnect black switch cable A from Main PC
board and connect it to the Remote Module terminal.
Connect white cable B from Remote Module to Main
PC board switch terminal.
A
B


Produkt Specifikationer

Mærke: Zephyr
Kategori: Controller
Model: RC-0001

Har du brug for hjælp?

Hvis du har brug for hjælp til Zephyr RC-0001 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Controller Zephyr Manualer

Zephyr

Zephyr RC-0001 Manual

13 August 2024

Controller Manualer

Nyeste Controller Manualer