Celly KHPOWERBANK Manual

Celly PowerBank KHPOWERBANK

Læs nedenfor 📖 manual på dansk for Celly KHPOWERBANK (36 sider) i kategorien PowerBank. Denne guide var nyttig for 14 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/36
Please read this manual and
pay attention to the safety
warnings before using the
product
Keep the manual to have the possibility
to consult it at a later time, or in case of
passing the product to a third party.
Esprinet S.p.A. can not in any way be held
responsible for injury or damage caused to
people or things resulting from improper
use of the product.
Safety notes
To avoid malfunction or damage to the
product, avoid accidental drops, crush,
puncture or exert a high level of pressure
on the product. is could cause an
internal short circuit and / or overheating.
Keep away from moisture, water or other
liquids. If the product comes into contact
with water, moisture or other liquids,
do not use the product to avoid electric
shock, explosion or damage.
If the product gets wet, even if it dries and
operates normally, the battery contacts
and circuitry may slowly corrode and pose
a safety hazard.
Do not store or expose the product to
any heat source, direct sunlight, radiators,
stoves or other heat sources such as the
dashboard of your car in the summertime.
is could cause the battery to explode or
affect performance. Never use the product
unsupervised.
During operation, the case will become
hot. Allow adequate ventilation. e
casing must never be covered.
Never use the product when moving
from a cold to a warm environment.
Condensation may form which, in some
cases, could damage the product.
Allow the product to reach room
temperature before plugging it back in and
using it again.
is could take several hours.
Usage temperature: 0-40 ° C.
Do not attempt to modify, repair
or disassemble the product. Risk of
explosion!
Do not leave the product in contact with
metal objects.
Metallic objects can interfere with
the electrical connections causing the
protection circuit to malfunction.
Stop using the product immediately if you
notice any swelling, dispersion or other
abnormality.
Do not use a damaged product.
Make sure that the cable provided for
charging the product is intact and does not
short circuit the charging ports.
A non-replaceable rechargeable battery
is built into the product, never open or
disassemble the product. Do not short-
circuit the battery contacts / terminals.
Do not dispose of the product in open
flames. Danger of explosion and fire!
Charge the battery regularly, even when
the product is not in use. is will extend
its life (at least once every 2 months)
Never charge the product when
unattended. While charging, place the
product on a heat-resistant surface. Heat
build-up is normal when charging.
Under no circumstances use aggressive
cleaning agents, alcohol or other chemical
solutions for cleaning as they could
damage the housing or even compromise
the functionality of the product.
Disconnect all connected cables before
starting cleaning. Do not immerse the
product in water or other liquids.
Do not press too hard on the housing to
avoid scratches and damage. Keep the
product out of the reach of children. Never
allow children or people with disabilities to
use electrical products unsupervised.
Make sure children do not play with
the plastic wrap. ey could swallow
fragments and choke.
Charging the power bank
1. Insert the small end of the supplied
USB-C cable into the USB-C port of the
powerbank.
2. Connect the larger end of the cable
included into the USB port of a charging
socket or computer. Charging of the power
bank will be started. We recommend 12-
hour charging for the first charge cycle.
While the power bank is charging, white
light will blink. If the power bank is fully
charged, white light will stop blinking. e
charging time is about 6 hours.
3. Unplug the USB-C cable from the power
bank's USB-C port after charging.
Loading devi
c
es
1. Make sure the power bank is sufficiently
charged.
2. Before charging the device, make sure
that the technical characteristics (Voltage,
output and amperage) are compatible with
the powerbank.
3. Connect the device to the USB port of
the powerbank using the original cable
supplied with your device. Charging of the
device will start.
4. Disconnect the device cable from the
device and the power bank after charging.
Cleaning
Disconnect all cables before cleaning.
If necessary, clean the power bank with a
damp cloth and allow it to dry completely
before use.
Use a clean brush with soft, long bristles
to remove dust from the connectors.
Do not use solvents, corrosive agents or
gaseous cleaners.
Make sure that water or other liquids do
not enter the housing.
Storage
Store the power bank in a clean and dry
area. Keep away from direct sunlight.
User information for proper
disposal (Directive 2013/56 / EU)
e crossed-out bin symbol shown
on the equipment or on its packaging
indicates that the product at the end of
its useful life, including the non-removable
battery, must be collected separately
from other waste to allow for proper
treatment and recycling. e safe use of
this product is guaranteed in compliance
with the following instructions, therefore
it is necessary to keep them and follow
them scrupulously throughout the life
of the product. e product does not
require technical maintenance, NEVER
DISASSEMBLE IT. e battery inside is
integrated and not replaceable. Do not
attempt to remove the built-in Lithium
Ion / Polymer battery yourself as it
may cause overheating, fire and injury.
e battery should only be removed by
independent qualified professionals who
are able to remove it safely and disposed
of in accordance with applicable laws. e
user must therefore give the equipment
at the end of its life free of charge to
the appropriate municipal centers for
the separate collection of electrical and
electronic waste, or return it to the
retailer, on a one-by-one basis, or free
of charge for appliances with smaller
external dimensions. to 25 cm. Adequate
separate collection for the subsequent
sending of the decommissioned
equipment for recycling, treatment and
environmentally compatible disposal helps
to avoid possible negative effects on the
environment and health and favors the
reuse and / or recycling of the materials
of which it is composed the equipment.
Illegal disposal of equipment, batteries
and accumulators by the user involves the
application of the penalties provided for in
the current legislation.
Technical specifications
Input: DC 5V/2A
Output 1: DC 5V/2.1A
Output 2: DC 5V/2.1A
USB-C Output: DC 5V/2.4A
Total output: DC 5V/2.4A
Capacity: 10000mAh/37Wh
Battery type: Li-ion
Weight: 202g
Dimensions: 141*67*17.5mm
Usage temperature: 0 – 40°
is product complies with RoHS
2011/65 / EU - 2015/863 / EU.
e product is marked with the
CE mark and complies with the safety
standards established by the European
Union.
© Keith Haring Foundation.
www.haring.com, Licensed by Artestar,
New York.
Produced under license by
Esprinet Spa,
Via Energy Park 20, 20871
Vimercate – MB (Italy)
Instruction manual
PORTABLE CHARGER
Model: KHPOWERBANK
Rev00 - 07.03.2023
EN


Produkt Specifikationer

Mærke: Celly
Kategori: PowerBank
Model: KHPOWERBANK

Har du brug for hjælp?

Hvis du har brug for hjælp til Celly KHPOWERBANK stil et spørgsmål nedenfor, og andre brugere vil svare dig




PowerBank Celly Manualer

PowerBank Manualer

Nyeste PowerBank Manualer

Fresh 'n Rebel

Fresh 'n Rebel 1PB100BL Manual

14 September 2024
AudioSonic

AudioSonic PB-1724 Manual

12 September 2024
Xtorm

Xtorm XR204 Manual

11 September 2024
König

König KNPB15000 Manual

10 September 2024
Bluetti

Bluetti X30 Manual

10 September 2024
Ansmann

Ansmann PB4100 Manual

6 September 2024
Goodis

Goodis GD-PB2148 Manual

6 September 2024