Celly PBPD45W15000 Manual

Celly power bank PBPD45W15000

Læs nedenfor 📖 manual på dansk for Celly PBPD45W15000 (15 sider) i kategorien power bank. Denne guide var nyttig for 29 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/15

Read this user manual and

in particular the safety notes

before using the product.

Keep the user manual for future reference

and include it when passing the product

on to third parties.

Esprinet S.p.A. will not in any way be held

responsible for injury or damage caused

to persons or property arising from misu-

se of the product.

Safety notes

To prevent malfunction or damage to the

product, avoid accidental falls, do not

crush, puncture or exercise a high level of

pressure on the product. is can cause

an internal short-circuit and overheating.

Keep away from humidity, water or other

liquids. If the product comes into contact

with water, moisture or other liquids, do

not use the product to avoid any electrical

shock, explosion or damage.

If the product gets wet, even if it is drying

up and operating normally, the battery

contacts and the circuitry could slowly

corrode and pose a safety hazard.

Do not store or expose the product to any

source of heat, direct sunlight, radiators,

stoves or other heat sources such as the

dashboard of your car in the summer. is

could cause the battery to explode or

compromising performance. Never opera-

te the product unsupervised.

During operation, the housing becomes

hot. Allow adequate ventilation. e hou-

sing must never be covered.

Never use the product when moving from

a cold to a warm environment. Condensa-

tion may occur and, in some cases, dama-

ge the product.

Allow the product to reach room tempera-

ture before connecting and using it again.

is could take several hours.

Temperature of use: 0–40 °C.

Do not try to modify, repair or disassem-

ble the product. Risk of explosion!

Do not leave the product in contact with

metal objects.

Metallic objects can interfere with the

electrical connections and cause an acci-

dent if the internal

protection circuit of the product is not

working properly.

Immediately stop using the product if you

see a bulge, dispersion or other abnorma-

lities.

Do not use a damaged product.

Make sure that the provided cable for

charging the product is intact and never

short-circuit the charging outputs.

A non-replaceable rechargeable battery

is integrated in the product. ere are no

serviceable parts inside the product. Ne-

ver open/disassemble it.

Never short circuit the contacts/battery

terminals.

Do not dispose of the product into ﬁre.

ere is danger of explosion and ﬁre!

Charge the battery regularly, even when

the product is unused. is will prolong its

lifespan (once time every 2 months)

Never charge the product when it is unat-

tended. While charging, place the product

on a heat resistant surface. Accumulation

of heat is normal during charging.

Do not under any circumstances use ag-

gressive cleaning agents, alcohol or other

chemical solutions for cleaning as they

can damage the housing or even impair

the functionality of the product.

Disconnect all connected cables before

you start cleaning. Do not immerse the

product in water or other liquids.

Do not press too hard on the housing to

avoid scratching. Keep the product out of

reach of children. Never allow children or

persons with disabilities to use electrical

products without supervision.

Make sure that children do not play with

the plastic wrapping. ey may swallow it

when playing and suﬀocate.

Charging the power bank

1. Insert the smaller end of the charging

cable in the power bank.

2. Connect the larger end of charging

cable into the USB port of a charging

socket or computer. Charging of the

power bank will be started. We recom-

mend 12-hour charging for the ﬁrst char-

ge cycle. While the power bank is char-

ging, white light will blink. If the power

bank is fully charged, white light will stop

blinking. e charging time is 3 hours.

3. Disconnect the charging cable from the

power bank after charging.

Charging your devices

1. Make sure the power bank is suﬃcient-

ly charged.

2. Before charging your device, make

sure its technical characteristics (voltage,

output and amperage) are compatible

with the power bank.

3. Connect your device to the USB port of

the power bank, using the device’s origi-

nal cable. Charging of your device will be

started.

4. Disconnect the device’s cable from the

device and the power bank after charging.

Cleaning

Disconnect all cables before cleaning.

If necessary, clean the power bank with

a damp cloth and let it dry completely

before use.

Use a clean brush with soft, long bristles

to remove dust on the connectors.

Do not use any solvents, corrosive or ga-

seous cleaning agents.

Make sure no water or other liquids pene-

trate the housing.

Storage

Store the power bank in a clean, dry area.

Keep it away from direct sunlight.

CUSTOMER’S INFORMATION

FOR RIGHT WASTE OF THIS PRO-

DUCT (Directive 2013/56/EU)

is marking on the product or its packa-

ging means that the product at the end of

its life, inlcuding the unremovable battery,

must be separated from other types of

waste to recycle it responsibly.

Safely’s use of this product is guarante-

ed from the respect of this instructions

manual, keep it and carefully use it for all

life of the product. e product doesn’t

need any kind of technical maintenance,

NEVER DISASSEMBLE IT. e battery

inside the product is integrated and not

replaceable. Don not try to remove li-ion/

polymer battery included in inside the

product because can produce overheat’s

danger, burning and injury. e battery

must be removed only by qualiﬁed profes-

sional techincians, that are able to remo-

ve it without any kind of danger and to

recycle it in the respect of the law. Users

should give free end of life product into

the local separate collection centers or

to the retailer, in reason of one to one,

or free if the product size is bigger than

25 cm. Adequated waste disposal permit

to award the product to recycling, treat-

ment with ecofriendy compatible disposal

conduce to prevent possible harm to the

environment or human health and pro-

mote the reuse and/or product materials

recycling. Unauthorized waste disposal of

electronic product, cell and battery from

houseold user involve currency legislation

sanctions.

Technical speciﬁcations

USB-C INPUT: DC 5V / 3A, 9V / 3A, 12V /

2.25A, 15V / 2A, 20V / 1.5A (30W)

USB OUTPUT 1/2: DC 5V / 3A, 9V / 2A,

12V / 1.5A (18W)

USB-C OUTPUT: DC 5V / 3A, 9V / 3A, 12V

/ 3A, 15V / 3A, 20V / 2.25A (45W)

TOTAL OUTPUT: 45W

WEIGHT: 300g

SIZE: 125x71.5x25mm

CAPACITY: 15000 mAh / 56Wh

RECHARGING TIME: 2h (PD)

BATTERY: LI-ION

TEMPERATURE OF USE: 0 - 40 °

is product complies with

RoHS 2011/65/EU - 2015/863/

EU. e product carries the CE

mark and complies with safety standards

established by the European Union.

e full text of the EU declaration of con-

formity is available at the following inter-

net address: www.celly.com

Celly® is a trademark owned by CELLY

S.p.A.

All brands are registered trademarks of

their respective owners.

Esprinet S.p.A., via Energy Park

20, 20871 Vimercate (MB) -

Italy

Made in China.

User manual

POWERBANK

Model: PBPD45W15000

rev01 - 04.03.2021

Produkt Specifikationer

Mærke:	Celly
Kategori:	power bank
Model:	PBPD45W15000
Bredde:	71.5 mm
Dybde:	25 mm
Højde:	125 mm
Vægt:	300 g
Produktfarve:	Sort
Batterikapacitet:	15000 mAh
Opladningskilde:	USB
Hurtig opladning:	Ja
Antal enheder der er tilsluttet samtidigt (maks.):	3
Oplader, kompabilitet:	Universel
Inputgrænseflade:	Micro-USB + USB Type-C
USB A udgangsporte:	2
Form:	Rektandel
Hurtig opladningsteknologi:	Quick Charge 3.0
USB strømforsyning:	Ja