Elba ETM-E3320 Manual

Elba Vandhane ETM-E3320

Læs nedenfor 📖 manual på dansk for Elba ETM-E3320 (1 sider) i kategorien Vandhane. Denne guide var nyttig for 14 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
A Tap Body
B Rubber O-ring
C Sink top or Work top
D Rubber O-washer
E Metal O-washer
F Threaded fixing bushing
G Flexi bose
H Rubber O-ring for flexi hose
1. An opening hole of 35mm diameter is required on sink top or work top for installation of tap.
2. Slide the rubber O-ring (B) over the threaded tube and up to the base of tap (A).
3. Insert the threaded tube through the hole of sink top or work top (C) and position the tap properly.
4. Slide the rubber O-washer (D) and metal O-washer (E) over the threaded tube and up to the underside of
sink top or work top (C).
5. Screw the fixing bushing (F) up to the metal O-washer (E).
6. Connect the flexi hoses (G) to the extension tube on one end and the hot or cold water supply on the other
end. Please ensure that the hot water supply goes through the hot flexi hose while the cold water supply goes
through the cold flexi hose.
(C)
ETM-E3820
Before installation, please ensure that the following work
conditions are adhered to:
-Water temperature between 0 C - 90 C˚ ˚
-Water pressure between 0.05MPa 1.0MPa. Pressure reducing
valve is necessary if pressure exceeds 1.2MPa
-Avoid major pressure dierences between hot and cold water
supply
Flush pipes thoroughly before and after installation to ensure
water supply is free of any debris.
Inspect tap fitting and debugged to its best. Do not attempt to
disassemble fitting on your own.
Use thread sealant tape (PTFE) on any screw joining
connections and ensure all joints are securely tightened.
ETM-E3320 ETM-E2920 ETM-E3920
This . FIAMMA SDN. BHD. will not be held responsible for the use of superseded or voided specifications.
Fabricatoe must check for cut-out accuracy.
specification is subject to change without notice
Stainless Steel Mixer Tap


Produkt Specifikationer

Mærke: Elba
Kategori: Vandhane
Model: ETM-E3320

Har du brug for hjælp?

Hvis du har brug for hjælp til Elba ETM-E3320 stil et spørgsmål nedenfor, og andre brugere vil svare dig