Jabsco 23620-4103 Manual

Jabsco Pomp 23620-4103

Læs nedenfor 📖 manual på dansk for Jabsco 23620-4103 (2 sider) i kategorien Pomp. Denne guide var nyttig for 13 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
MODELS:
23620-4003 12V
23620-4103 24V
MINI PUPPY
FEATURES:
Continuous rated, medium duty pumps for
bilge and general purpose use.
zISO 8846 MARINE (Ignition protection).
zISO 8849 MARINE (Bilge pump standard).
zSmall bilge debris present no problem to
these brass bodied, flexible impeller
pumps.
zSimple design means fewer wearing
parts.
z6 lpm (1.3 UK gpm) output @ 2m (6.6ft)
head.
zSelf priming to 1.5m (5 ft).
INSTALLATION INSTRUCTIONS:
Jabsco Mini Puppy can be mounted on any flat
surface. Fit the pump in a dry, well ventilated
position where there is full access for service. If
installed in a vertical position the motor must be
above the pump head. Use the rubber grommets
provided to minimise vibration, do not overtighten the
mounting screws.
Secure 25.4mm (1”) id hose direct to the discharge
ports using stainless steel hose clamps, or use 3/8
BSP / NPT pipe fittings using suitable jointing tape.
Use spiral reinforced hose (with a smooth internal
bore) that will not collapse under suction, or rigid or
semi rigid pipework systems. The pipework must be
compatible with the liquid being pumped. Pipe runs
should be kept as straight and short as possible,
avoiding rising and dipping over obstructions. Fit a
strainer on the inlet hose to prevent larger debris
from entering the pump.
WIRING INSTRUCTIONS
Make all electrical connections in dry locations,
connections in humid environments should be sealed
to prevent corrosion. Protect the circuit with a
correctly rated fuse or circuit breaker in the red
positive (+) lead as close as possible to the power
source. Connect the black motor wire to the negative
(-) battery terminal. Inadequate voltage at the motor
terminals when the pump is running (not less than
10% below rated voltage at full load) due to partially
discharged batteries or insufficient cable size may
result in blowing fuses, failure to start or poor pump
performance.
WARNING: If the fuse fails
repeatedly do not fit a heavier fuse or
bridge the fuse terminals with silver
paper or metal wire. Failure to observe
this instruction may result in a fire
hazard due to overheating of cables.
WARNING: All marine pumps
discharging overboard must be
installed with the overboard discharge
well above both static and heeled
waterlines.
m ft lpm UK gpm
2 6.6 6 1.5
4 13 5 1.3
6 19.7 4 1.1
8 26.2 2.8 0.9
MINI PUPPY PERFORMANCE
TOTAL HEAD MINI PUPPY
Approximate performance for new pump,
running water at 20°C with fully charged battery
WARNING: Do not use any Jabsco
pump for petrol, petroleum products or
any products with a flash point below
37°C (98°F), explosion or death may
occur.


Produkt Specifikationer

Mærke: Jabsco
Kategori: Pomp
Model: 23620-4103

Har du brug for hjælp?

Hvis du har brug for hjælp til Jabsco 23620-4103 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Pomp Jabsco Manualer

Pomp Manualer

Nyeste Pomp Manualer

Ozito

Ozito PTP-012A Manual

15 Oktober 2024
MSW

MSW -MN34 Manual

15 Oktober 2024
MSW

MSW -MN34M Manual

15 Oktober 2024
MSW

MSW -AOP40S Manual

15 Oktober 2024
Nefit

Nefit VentiLine Manual

12 Oktober 2024
Liberty Pumps

Liberty Pumps 250 Manual

30 September 2024
Liberty Pumps

Liberty Pumps 457 Manual

30 September 2024