Rolls PM351 Manual

Rolls Øreprop PM351

Læs nedenfor 📖 manual på dansk for Rolls PM351 (2 sider) i kategorien Øreprop. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Connection guide
Rolls Corporation
Salt Lake City, UT
9/18
What's in the box?
1 - Made in USA PM351
1 - 15V power supply PN PS27s
1 - This owners manual
PM351 Personal Monitor
SPECIFICATIONS
Max Input Level: -20 dB XLR, +40 dB Line
+15 dB Instrument
Inst. Input Impedance: 50K ohms
Inst. Output Freq. Response: 10 - 30 kHz +/- 3 dB
Output Impedance, Hdphn: 10 ohms
Output Impedance, Inst.: 2 ea; 100 ohms balanced
Gain: 20 dB 1/4", 50 dB XLR
Hdphn Freq. Response: 20 - 20 kHz
S/N Ratio: 90 dB
Power: 9 - 16 VDC
Size (W x H x D): 4.5" x 3.3" x 1.5"
Weight: 1 lb (.45 Kg)
Remote Powering the PM351
A very useful feature of the PM351 is the ability to send the
12-15VDC power to the unit via the LINE INPUT ring con-
nection. Make sure the Mono/Stereo switch is in the MONO
position. Connect the 12-15VDC to the Ring of the TRS plug
as shown here.
ROLLS WILL NOT BE HELD RESPONSIBLE FOR DAMAGE
DONE TO THE PM351 AS A RESULT OF IMPROPER USE OF
THIS FEATURE. IF YOU ARE NOT SURE HOW TO DO THIS COR-
RECTLY, CONTACT A QUALIFIED SERVICE TECHNICIAN.
NOTE: This unit cannot be powered by standard 48 Volt
Phantom Power supplied by mixers, phantom power adapt-
ers etc. The current (amperes) is insucient to power the
PM351. Also, any voltage greater than 16 VDC will damage
the unit.
CONNECTION
The LINE INPUT connects to either a 1/4" stereo or mono plug.
If this plug is Tip-Ring-Sleeve stereo and you're sending a stereo
signal to this jack, select the STEREO setting of the Mono/Stereo
switch. If the plug is Tip-Sleeve mono, select the MONO setting
of the Mono/Stereo switch. The MONO setting is also the proper
selection if you are phantom powering the PM351.
The MIC INPUT connects to either a dynamic or condenser micro-
phone via a standard XLR cable. If you are using a condenser type
mic, you will need to power it via phantom power from the mixer
which connects to the MIC THRU jack. This jack will pass the phan-
tom power from a mixer on to the microphone.
• Connect the MIC THRU jack to the mixer or snake as necessary.
The INSTRUMENT INPUT connects to a guitar preamp output,
keyboard, or any stereo or mono instrument level signal. Again,
select stereo or mono.
The INSTRUMENT OUTPUTS are transformer isolated and con-
verts the high impedance INSTRUMENT INPUT signal to low im-
pedance so it can be sent down a balanced line. These signals may
then be plugged into an XLR input on a mixer or snake. Note that
the level of this signal may be too high for a mixer's microphone
input - you may experience distortion. In this event, turn down
the instrument connected to the PM351 INSTRUMENT INPUT, pad
the input to the mixer's mic input, or trim down the mic input.
Connect your headphones to the proper Headphone Output.
PM351 is designed for performers who want to
monitor their own sounds, such as their vocals
and instruments, with the main mix via head-
phones. Its very popular with drummers who
need to mix a click track with a monitor signal.
Church choir singers love the PM351 to monitor
their voices over the musicians.


Produkt Specifikationer

Mærke: Rolls
Kategori: Øreprop
Model: PM351

Har du brug for hjælp?

Hvis du har brug for hjælp til Rolls PM351 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Øreprop Rolls Manualer

Rolls

Rolls PM-50s Manual

27 August 2024
Rolls

Rolls PM55P Manual

27 August 2024
Rolls

Rolls PM351 Manual

27 August 2024

Øreprop Manualer

Nyeste Øreprop Manualer