Sierra Designs Sirius 3 Manual

Sierra Designs Fuld Sirius 3

Læs nedenfor 📖 manual på dansk for Sierra Designs Sirius 3 (1 sider) i kategorien Fuld. Denne guide var nyttig for 14 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
SIERRA DESIGNS 2011 Cherry Street, Unit 202 Louisville, CO 80027 Phone: 303-262-3050 Fax: 303-262-3051 Toll Free: 800-635-0461
S I E R R A D E S I G N S
semitaught and stake them down. Staking out points C and
D is recommended in especially high winds.
Erect the Tent
The pole should be laid out parallel to the length of the
tent, A-E axis. Rotate the poles so that the tips of the poles
are separated (Figure 3). Insert the tips of the poles into
the grommets at points E and F. Move to the other side of
the tent and grab each pole end and insert the tips into the
grommets at points A and B. Starting at Point G clip all of
the swift clips to the poles along the A F and B – E axis
Fly Sheet
At points E, F, J, and I are side-release “fly clip” buckles
(Figure 6). Drape the fly sheet over the tent so the orange
“fly clip” attachment on the rainfly at point J is aligned with
the orange “fly clip” attachment at point P on the tent body.
By clipping the orange webbing strap on the rainfly to the
orange webbing strap on the body, you are guaranteed a fast,
proper, rainfly setup every time. Attach the fly to the tent
poles via Velcro® located at points I, J, L, and M. Clip the
remaining “fly clip” buckles at points E, F, and I and pull
the straps at points E and F until the fly is taught (Figure 5).
Now pull point H out until the rainfly is taught and stake
to the ground. Do the same with point K. You can use a guy
line to guy out the fly at points L, M, and N for increased
stability and ventilation.
The long Velcro straps located at points I and J are to al-
low you to roll back your rainfly by unclipping points E and
F to give you maximum ventilation and night sky viewing.
Ventilation
With the rainfly on, several things can be done to increase
airflow. The best airflow through the tent is obtained by
pitching the tent with points A and B into the wind, with
points L, M, and N guyed out. (In heavy winds it is suggest-
ed to pitch tent with points E and F facing into the wind).
First Pitch
In order to familiarize yourself with your new tent, we
suggest that youtest pitch” it before embarking on a
wilderness trip.
Select a Site
Look for a level spot that is protected from the wind in
order to ensure sleeping comfort. Clear the area of debris such
as sharp stones and sticks which might abrade or puncture
the tent floor. Choose an area that will drain
well when it rains.
Unfurl the Tent and Assemble the Poles
Unfurl the tent and lay the tent floor flat on the ground with
the door unzipped. Carefully unfold the shock corded pole
sections and allow them to slide together. Do not allow the
poles to snap together: This can lead to serious pole damage.
Make certain that the insert of each pole section is fully in-
serted into the next pole section (Figure 1). You will have one
main pole where all sections are connected by the Sierra De-
signs Quick Pitch Swivel Hub w/ H-clip (Figure 2).
Stake out the Tent Floor
Although the Sirius 3 is a completely freestanding tent, we
suggest that you always stake out the floor for greater safety
and stability, especially in high winds. First stake down
the webbing loops at the back of the tent at points E and F
(Figure 4). Then move to the front of the tent and pull the
webbing loops at points A and B until the floor is square and
SIRIUS 3
Your Sierra Designs
SIRIUS 3 tent is very
easy to pitch and maintain.
Follow these instructions
to pitch your tent quickly,
safely and easily.
insert
incorrect
correct
Figure 4: Tent Body (top view)
Figure 1: Correct Pole Assembly
Figure 6: Fly Clip
F
M
N
L
K H
IJ
E
B D
C
P
O
G
F
A E
Figure 5: Tent Fly (top view)
Figure 2: Quick Pitch Swivel Hub w/ H-clip
(side view)
Figure 3: Quick Pitch Swivel Hub w/
H-clip (top view)
SIRIUS 3 TENT CONTENTS
* Sierra Designs tent s include stakes for pitching the body and fly under normal conditions.
Additional stakes may be required in severe conditions.
Tent Body and Rainfly: 1
Tent Poles: 1
Tent Stakes: 6 *
Guy Cord: 4
Line Tighteners: 4
Pitching Instructions: 1
Pole Sack: 1


Produkt Specifikationer

Mærke: Sierra Designs
Kategori: Fuld
Model: Sirius 3

Har du brug for hjælp?

Hvis du har brug for hjælp til Sierra Designs Sirius 3 stil et spørgsmål nedenfor, og andre brugere vil svare dig