Supermicro A4SAP-E Manual
Supermicro
Bundkort
A4SAP-E
Læs nedenfor 📖 manual på dansk for Supermicro A4SAP-E (1 sider) i kategorien Bundkort. Denne guide var nyttig for 9 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/1
SUPERMICR R
ContaCt nformatIon I
• Manuals: http://www.supermicro.com/support/manuals
• Drivers & Utilities: https://www.supermicro.com/wdl/driver/
• Safety: http://www.supermicro.com/about/policies/safety_information.cfm
© 2024 Supermicro Computer Inc. All rights reserved. Reproduction of this document whether in part or in whole is strictly prohibited without Supermicro's written
consent. All Trademarks are property of their respective entities. All information provided is deemed accurate at the time of printing; however, it is not guaranteed.
A4SAP-H/-E/-L
Q R G 1.0uick EfEREncE uidE 0
• Website: www.supermicro.com
• General Information: marketing@supermicro.com
• Technical Support: support@supermicro.com
• Phone: +1 (408) 503-8000, Fax: +1 (408) 503-8008
F or your system to work properly please download appropriate,
drivers images user s manual From the links below/ / ' :
MNL-2701-QRG-100
WARNING: This product can expose you to chemicals including
lead, known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information, go
to www.P65Warnings.ca.gov.
!
SRW2
SRW1
MH4
MH2
MH1
MH3
CN1
JLCDPWR1
BT1
JDC1
1
JMP1
JF1
JPWR1
I-SATA1
JGP1
JLAN1
JLAN2
JCOM1
2
JUSB1
JHDMI1
LVDS1
JEIO_1
A4SAP-L
Rev:1.02
J6 J3
JMD1
DIMM1
261
JSMBUS1
DESIGNED IN USA
SoC
D 36199
Jumpers and ConnectorsMotherboard Layout and Features
Note: Graphics shown in this quick reference guide are for illustrational purposes only. Your components may or may not look exactly the same as drawings
shown in this guide.
Note: Refer to the Component Installation section of the user manual for detailed information on jump-
ers, connectors, and LED indicators.
Note: Refer to the Component Installation section of the user manual for detailed information on
memory support and processor/motherboard installation instructions.
Processor and Memory Support
Front Control Panel (JF1)
The A4SAP-H/-L supports the Intel
® Processor N97.
The A4SAP-E supports the Intel Atom®
Processor x7433RE.
Connector Description
BT1 Battery Connector (To clear CMOS, remove the battery, short
pins 1–2 for more than three seconds, and install the battery.)
CN1 Nano SIM Card Slot
I-SATA1 SATA 3.0 Port
J3 Front Panel Audio Header (Line-out, Mic-in)
J6 USB 2.0 p1-x2 Header
JCOM1 COM Header
JDC1 +12 V DC Jack Power Connector (A4SAP-H only)
JEIO_1 Supermicro Extension I/O Header (DP/HDMI, one PCIe x1,
two USB 2.0, eSPI, SATA (A4SAP-H only), SMBus, +5 Vsb,
+12 Vsb)
JF1 Front Control Panel Header
JHDMI1 High Denition Multimedia Interface (HDMI) Port
JGP1 General Purpose I/O Header
JLAN1, JLAN2 1G LAN Ports (A4SAP-E/-L)
2.5G LAN Ports (A4SAP-H)
JMD1 M.2 B-Key 2242/3042 Slot with Nano SIM
(PCIe x1/SATA 3.0/USB 2.0/USB 3.0)
JMP1 M.2 E-Key 2230 Slot (PCIe x1/USB 2.0)
JPWR1 2x4-pin 12 V Power Connector (A4SAP-E/-L only)
JSMBUS1 SMBus or I2C and +5 V/+1 A SATA Power Box Header
JUSB1 Two USB 3.2 Ports
LVDS1 Dual Channel 48-bit LVDS Connector
32-pin Connector A Front panel, 8-bit GPIO and USB 2.0 x 2 (JF1 + JGP1 + J6)
(A4SAP-H only)
34-pin Connector B RS232/422/485 x 2 and Audio (JCOM1 + J3) (A4SAP-H only)
MH1–MH4 Mounting Holes
SRW1, SRW2 M.2 Mounting Holes
I/O Ports
1 13 35 5 6
4 4
2 2
87
+3.3 V Stby
+3.3 V HDD LED
Power LED
21
Reset Button
Power Button
GND
GND
Jumpers
Connectors
A4SAP-E/-L A4SAP-H
# # #Denition Description Description
1 3 5LAN1 HDMI USB1 (USB 3.2)
2 4 6LAN2 USB2 (USB 3.2) JDC1 (A4SAP-H)
Top Layout
Bottom Layout
= mounting hole
Jumper Description Jumper Setting (Default *)
JLCDPWR1
FORCE POWER ON Pins 2–4* (FORCE POWER ON)
Pins 4–6 (POWER BUTTON ON)
LVDS VCC Power Selection Pins 1–3* (+3.3 V)
Pins 3–5 (+5 V)
1. After the memory installation is
complete, install the heatsink.
2. The thermal solution kit that comes
with the motherboard includes one
heatsink with thermal grease and
four copper standos that are 19
mm in height.
3. To install the heatsink, remove the
plastic cover on the bottom of the
heatsink to expose the thermal
grease. Then place the heatsink
directly on the processor and make
sure the thermal grease is in con-
tact with the processor.
4. Turn the motherboard over and
tighten the standos with the cor-
responding screws.
Heatsink Installation
Package Contents
Single Package Content for A4SAP-E/-L
• One A4SAP-E/-L Motherboard
• One Quick Reference Guide
• One Power Input Cable
• One SATA Data Cable
• One SATA Power Cable
• One USB 2.0 Cable
• One Audio Cable
• One COM Port Cable
• One Passive Heatsink
Single Package Content for A4SAP-H
• One A4SAP-H Motherboard
• One Quick Reference Guide
• One Audio Cable
• One COM Port Cable
• One Passive Thermal Solution
The A4SAP-H/-E/-L motherboard supports up to 16 GB of Non-ECC DDR5
SO-DIMM with speeds of up to 4800 MT/s in one memory slot.
SO-DIMM Memory Installation
Memory Support
Align
1. Position the SO-DIMM module's bottom key so it aligns with the receptive
point on the slot.
2. Insert the SO-DIMM module vertically at about a 45-degree angle. Press
down until the module locks into place. The side clips will automatically
secure the SO-DIMM module, locking it into place.
Insert this end rst
Locking Clip
32-pin Connector A 34-pin Connector B
1. Push the side clips at the end of slot to release the SO-DIMM module. Pull
the SO-DIMM module up to remove it from the slot.
SO-DIMM Memory Uninstallation
Produkt Specifikationer
| Mærke: | Supermicro |
| Kategori: | Bundkort |
| Model: | A4SAP-E |
Har du brug for hjælp?
Hvis du har brug for hjælp til Supermicro A4SAP-E stil et spørgsmål nedenfor, og andre brugere vil svare dig
Bundkort Supermicro Manualer
18 December 2024
6 December 2024
6 December 2024
6 December 2024
6 December 2024
6 December 2024
5 December 2024
6 Oktober 2024
4 September 2024
3 September 2024
Bundkort Manualer
- Bundkort Asus
- Bundkort Gigabyte
- Bundkort Asrock
- Bundkort MSI
- Bundkort NZXT
- Bundkort ECS
- Bundkort Sapphire
- Bundkort Intel
- Bundkort Sharkoon
- Bundkort Biostar
- Bundkort Evga
- Bundkort Foxconn
- Bundkort Advantech
- Bundkort Elitegroup
- Bundkort EPoX
- Bundkort AOpen
Nyeste Bundkort Manualer
14 Januar 2025
14 Januar 2025
13 Januar 2025
13 Januar 2025
12 Januar 2025
12 Januar 2025
12 Januar 2025
12 Januar 2025
12 Januar 2025
12 Januar 2025