TriStar BD-4611 Manual

TriStar Blodtryksmåler BD-4611

Læs nedenfor 📖 manual på dansk for TriStar BD-4611 (3 sider) i kategorien Blodtryksmåler. Denne guide var nyttig for 14 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/3

EN | Instruction manual

PT | Manual de utilizador

PARTS DESCRIPTION / DESCRIÇÃO DOS COMPONENTES

DISPLAY

WWW.TRISTAR.EU

Tristar Europe B.V. | Jules Verneweg 87

5015 BH Tilburg | The Netherlands

ENInstruction manual

SAFETY

MEDICAL DISCLAIMER: This device and manual are not meant

to be a substitute for advice provided by doctors or other

medical professionals.

Contact your physician for interpretation of measurements, or if

you have or suspect you have a medical issue.

• By ignoring the safety instructions the

manufacturer can not be hold

responsible for the damage.

• Not for use by children, pregnant women,

or pre-eclamptic patients.

• Prolonged over-inflation of the monitor

will result in harmful injury to the patient.

• Do not use this device over a wound, as

this can cause further injury.

• Too frequent measurements can cause

injury due to blood flow interference.

• Do not attempt to modify this device in

any way.

• Never move the appliance by pulling the

cord and make sure the cord can not

become entangled.

• The appliance must be placed on a

stable, level surface.

• This product is for household use only. It

is not intended as a substitute for

consultation with your doctor.

• For users diagnosed with common

arrhythmia (atrial or ventricular

premature beats or atrial fibrillation),

diabetes, poor circulation of blood,

kidney problems, or for users suffered

from stroke, or for unconscious users,

the device might not be suitable for use.

Consult your doctor in case of any doubt.

• The unit should not be operated by

children to avoid hazardous situations.

• The unit contains high-precision

assemblies. Therefore, avoid extreme

temperatures, humidity and direct

sunlight. Avoid dropping or strongly

shocking the main unit, and protect it

from dust.

• Leaking batteries can damage the unit.

Remove the batteries when the unit is

not used for a long time.

• If the unit is stored in a cold place, allow

it to acclimatize at room temperature

before use.

• To avoid inaccurate results caused by

electromagnetic interference between

electrical and electronic equipment’s, do

not use the device near a cell phone or

microwave oven.

• To protect yourself against an electric

shock, do not immerse the cord, plug or

appliance in the water or any other liquid.

• This appliance shall not be used by

children. This appliance can be used by

persons with reduced physical, sensory

or mental capabilities or lack of

experience and knowledge if they have

been given supervision or instruction

concerning use of the appliance in a safe

way and understand the hazards

involved. Children shall not play with the

appliance. Keep the appliance and its

cord out of reach of children. Cleaning

and user maintenance shall not be made

by children.

SAFETY BATTERIES

• Do not expose the battery to high

temperatures or direct sunlight. Never

throw batteries into the fire. There is a

danger of explosion!

• Keep batteries away from children.

Batteries are not a toy!

• Do not open the batteries by force.

• Avoid contact with metallic objects.

(Rings, nails, screws et cetera) there is a

danger of short-circuiting!

• As a result of a short-circuit batteries

may heat up consider-ably or even catch

fire. this may result in burns.

• For your safety the battery poles should

be covered with adhesive strips during

transport.

• Do not touch a ruptured and/or leaking

battery. If the liquid from the battery gets

into your eyes, rinse your eyes as soon

as possible with clean water, without

rubbing your eyes. Immediately go to the

hospital. If it is not treated properly, it can

cause eye problems.

BLOOD PRESSURE

What is blood pressure?

Blood pressure is the pressure exerted on the artery tube while

blood flows through the arteries. The pressure measured when

the heart contracts and sends blood out of the heart is systolic

(highest). The pressure measured when the heart dilates with

blood flowing back into the heart is called diastolic (lowest)

blood pressure.

Why measure your blood pressure?

Among the various health problems afflicting modern people,

problems associated with high blood pressure are by far the

most common. High blood pressure's dangerously strong

correlation with cardiovascular diseases and high morbidity has

made measuring blood pressures a necessity of identifying

those at risk.

Blood pressure standard.

The World Health Organization (WHO) and National High Blood

Pressure Education Program has developed a Blood pressure

standard, according to which areas of low and high-risk blood

pressure are identified. This standard however, is a general

guideline as individual's blood pressure varies among different

people and different groups...etc.

It is important that you consult your physician regularly. Your

physician will tell you your normal blood pressure range as well

as the point at which you will be considered at risk.

Blood pressure fluctuation

Blood pressure fluctuates all the time!

You should not be worried if you encountered two or three

measurements at high levels.

Blood pressure changes over the month and even throughout

the day depending on circumstances (state of mind,

temperature, ...)

Blood pressure measurements determined with this device are

equivalent to those obtained by a trained observer using the

cuff/ stethoscope auscultatory method, within the limits

prescribed by European Society of Hypertension International

Protocol revision 2010 for the validation of blood pressure

measuring devices in adults.

An irregular heartbeat (IHB) rhythm is defined as a rhythm that

is more than 25% slower or 25% faster from the average rhythm

detected while the device is measuring the systolic blood

pressure and the diastolic blood pressure. When the device

detects an irregular rhythm two or more times during the

measurement, the Irregular Heartbeat Symbol will be displayed

with the measurement values.

PARTS DESCRIPTION

1. Display

2. USB power supply port

3. Memory button

4. Start/stop button

5. Set button

6. Cuff

Display

1. Systolic pressure

2. Diastolic pressure

3. Average value unit indicator

4. Pulse rate

5. Heartbeat

6. IHB

7. Memory times Year/date/time

8. User number

9. Blood pressure classification

10. Low battery

BEFORE THE FIRST USE

• Take the appliance andaccessoriesoutthebox.Removethe

stickers,protective foilorplasticfrom thedevice.

Battery Installation:

1. Take off the battery cover, located on the back of the device.

2. Insert three AA alkaline batteries according to the + and –

markings.

3. Snap the battery cover on, ensuring it clicks into place.

Make sure that the battery cover is securely in position.

4. NOTE: When the low battery symbol appears on screen,

turn off the device and follow the instructions above to

replace batteries.

Setting user, year, date and time:

• With device turned off, press and hold “set” button until

flashing year digits occur.

• Press “mem” to increase one year, or press and hold “mem” to

increase years. Press “set” to confirm and then flashing month

digits occur.

• Press “mem” to increase one month, or press and hold “mem”

to increase months. Press “set” to confirm and then flashing

day digits occur.

• Press “mem” to increase one day or press and hold “mem” to

increase days. Press “set” to confirm and then flashing hour

digits occur.

• Press “mem” to increase one hour or press and hold “mem” to

increase hours. Press “set” to confirm and then flashing minute

digits occur.

• Press “mem” to increase one minute or press and hold “mem”

to increase minutes. Press “set” to confirm and then either “12”

digits occur for 12-hour system or “24” digits occur for 24-hour

system.

• Press “mem” to toggle between “12” for 12-hour system and

“24” for 24-hour system. Press “set” to confirm and then

pressure unit digits occur.

• Press “mem” to toggle between “mmHg” and “kPa”. Press “set”

to confirm and flashing year occur again, or press “start/stop”

to confirm and then the device turns off.

• Setting is completed.

Note: Pressing “start/stop” will confirm the setting and then the

device turns off at any time.

Setting the user

With device turned off, press and release “set” button to show

the current user. Press “set” button to toggle between User 1

and User 2. To select user, press “start/stop” to confirm and

then the device turns off.

USE

Before Taking a Measurement

• For most accurate results, measurements should be taken in

the same circumstances and at the same time every day.

• This device can be applied to either arm, but preferably the

left. Use the same arm for each measurement.

• Any blood pressure recording can be affected by the position

and physiological condition of the subject, as well as other

factors such as background noise, stress, talking and body

movement etc.

• Avoid taking measurements while under stress.

• Do not eat, drink alcohol, smoke, exercise, or bathe 30

minutes before using this device, as these activities may

change blood pressure.

• For an accurate indication of true blood pressure, take and

record several measurements over a period of time.

• If consecutive measurements are desired, allow two minutes

between uses to allow blood to flow through the arm normally.

• This device is used to monitor blood pressure. However, it

cannot treat or prevent high blood pressure. If you suffer from

high blood pressure, consult your doctor. Self-diagnosis and

treatment using readings may be dangerous. Follow the

instructions of your physician or licensed healthcare provider.

Measurement

• This device should be used on bare skin. If necessary, loosely

roll up your sleeve to expose the arm. Note that your arm

cannot be tightened by your sleeve.

• With the hose down the inside of your arm and the bottom of

the cuff approx. 1~2cm above your elbow, wrap the cuff

around your arm. Secure the cuff with a finger space between

the cuff and your arm by attaching hook-and-loop fastener.

• Comfortably seated, legs uncrossed, feet flat on the floor, back

and arm supported, relax as much as possible and do not talk

during the measurement.

• While sitting upright in a chair with your feet flat on the floor,

press “start/stop". Symbols on screen will flash and cuff will

begin to inflate. Do not move, activate arm muscles, or talk

during measurement.

• Measurement can be stopped at any time by pressing “start/

stop".

• When this device senses a pulse, a heart symbol will flash on

screen.

• When measurement is complete, the cuff deflates

automatically and your systolic pressure, diastolic pressure,

and pulse rate will display on screen.

• Turn off this device by pressing “start/stop", remove from your

arm by detaching hook-and-loop fasteners. If this device is

accidentally left on, it will turn itself off after two minutes.

NOTE: This device will remain set on the same user after you

turn it off. To change to the other user, turn this device off, then

press and release “set” to access user setting. Either the user 1

or user 2 icon will appear. Press “set” to switch to the other user

icon and press “start/stop” to confirm the user and then the

device turns off.

Using Memory-Recall

This device will store up to 90 measurements each for two

users. When more than 90 measurements are taken, the oldest

measurement will be replaced.

• To access memory-recall, press and release “mem” while the

device is off.

• First, it will display the average of your three most recent

measurements, indicated on screen as M AVG (measurement

average).

• Press “mem” again to see the most recent measurement.

Press “mem” repeatedly to scroll towards the oldest

measurement. On screen, M01 indicates the most recent

measurement, with higher M numbers indicating older

measurements.

• If you desire to delete all stored measurements, press and

hold “set” under the Memory-recall status until “dEL no” is

displayed with “no” flashing. Press and release “set” to switch

to “dEL yes” with “yes” flashing.

• Press “start/stop” with “dEL yes” to confirm clearing the

memory and then blank entry appears on screen, or press

“start/stop” with “dEL no” to go back to the memory-recall

status without clearing the memory.

• Press “start/stop” to exit.

TROUBLESHOOTING

Trouble Possible reasons Solution

Produkt Specifikationer

Mærke:	TriStar
Kategori:	Blodtryksmåler
Model:	BD-4611

Har du brug for hjælp?

Hvis du har brug for hjælp til TriStar BD-4611 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Blodtryksmåler TriStar Manualer

TriStar BD-4611 Manual

6 August 2024

Blodtryksmåler Manualer

Nyeste Blodtryksmåler Manualer

Mx Onda MX-CP2395 Manual

17 November 2024

A&D Medical UB-525 Manual

28 Oktober 2024

Homedics BPA-P200 Manual

28 Oktober 2024

Cresta BPM701 Manual

4 Oktober 2024

Sanitas SBC 23 Manual

4 Oktober 2024

Omron RS1 Manual

3 Oktober 2024

Beurer PO 60 Manual

2 Oktober 2024

Medisana MTP Pro Manual

2 Oktober 2024

Medel Palm Self Manual

27 September 2024

Medel Dualstetho PRO Manual

27 September 2024